The main part of the hydraulic circuit of the hydraulic stabilization platform (HSP) is the electro-hydraulic servo valve (EHSV), which is very expensive due to its manufacturing requirements, so the proper selection for the geometrical configuration of electro hydraulic servo valve (EHSV) and maintaining the system stability are the main goal for establishing HSP. Also improving the performance of (HSP) to achieve the position tracking in two degrees of freedom (2DOF) based on modifying the different parameters of the hydraulic circuit (actuator size - hydraulic servo actuator geometric configuration - different load on the platform) to achieve the best performance. The system offers a proposal for an upper stabilized platform with moving lower base to be used with ships to achieve a stabilization condition for many purposes such as radar. MATLAB Simulink and Simscape-multibody has been used in modeling the system. Changing the different parameters in the program block library input data (orifice area and spool slot width) to achieve best configuration of the system to be stabilized is discussed. The results show that using 0.6 mm² servo valve orifice area and more raises the system pressure and has a bad effect on system stability, also using 4 mm servo valve slot width has more fluctuation in the system pressure in the transient time than using (3, 2 or 1)mm slot width until approaching stable condition but has a better effect on system stability in the running (operation) time.