The rot-HP did not decrease biomechanical stress in the shoulder or lower arm muscles. However, wrist angle position may be optimized without affecting precision. Long-term effects of the rot-HP on preventing complaints of the upper extremity should be evaluated. Low WH is recommended to reduce biomechanical stress in the shoulder during laparoscopic surgery.

Objective To evaluate the effect of a laparoscopic instrument with a 360° rotatable handle piece (rot-HP) on biomechanical stress and precision in different areas of a simulated operating field at two working heights. Background Surgeons performing laparoscopic procedures are exposed to biomechanical stress and have an increased risk of musculoskeletal complaints. Method Fifty-seven healthy subjects (27 men, median age 26) without experience in laparoscopy performed a precision task in four quadrants (A-D) of the operating field using the rot-HP or a common fixed handle piece (fixed-HP) at an individually adjusted lower or higher working height. Biomechanical stress was assessed by surface EMG, wrist joint angles, and arm postures and precision by the number of mistakes. Results Using the rot-HP reduced muscle activity of the biceps brachii and flexor carpi radialis muscle. An interaction of flexor activity and area of the operating field occurred with the lowest activity in Quadrant C. Wrist joint angles were more neutral using the rot-HP, especially when the lower working height was applied and in Quadrants B and C. However, increased wrist dorsal flexion occurred in Quadrant A while using the rot-HP. Arm postures and precision were less affected. Conclusion The rot-HP allows some reductions of stresses in the arm and hand region, whereas the stress in the shoulder neck region is not modified. Application The instrument's position and the working height may have to be considered as mediatory factors when describing the effectiveness of an ergonomic handle design for laparoscopic instruments.