The aim of the present study was to compare the cutting efficiency of Twisted File instruments used in continuous rotation or TF Adaptive motion and evaluate if prolonged use significantly affected their cutting ability. 20 new NiTi instruments were used in the present study (TF tip size 35, 0.06 taper; Sybron-Endo, Orange, CA, USA), divided into 2 subgroups of 10 instruments each, depending on which movement was selected on the endodontic motor. Group 1: TF instruments were activated using the program TF continuous rotation at 500 rpm and torque set at 2 N; Group 2: TF instruments were activated using the reciprocating TF Adaptive motion. Cutting efficiency was tested in a device developed to test the cutting ability of endodontic instruments. Each instrument cut 10 plastic blocks (10 uses) and the length of the surface cut in a plastic block after 1 min was measured in a computerized program with a precision of 0.1 mm. Maximum penetration depth was calculated after 1 use and after 10 uses, and mean and standard deviation (SD) of each group was calculated. Data were statistically analyzed with a one-way ANOVA test (P < 0.05). TF instruments used in continuous rotation (Group 1) cut a mean depth of 10.4 mm (SD = 0.6 mm) after the first use and 10.1 mm (SD 1.1 mm) after 10 uses, while TF instruments used with the Adaptive motion cut a mean depth of 9.9 mm (SD = 0.7 mm) after the first use and 9.6 mm (SD = 0.9 mm) after 10 uses. There was no statistically significant difference between the two groups investigated (P > 0.05) nor between instruments after 1 or 10 uses. In conclusion, the TFA motion showed a lateral cutting ability similar to continuous rotation and all tested instruments exhibited the same cutting ability after prolonged use.

Accessibility of the Italian public administration web pages is ruled by the Stanca Act and in particular the Decree of the Minister issued on July 8, 2005. In this paper, an objective test is performed on the official web pages of the Italian province and region chief towns to check their compliance to the 22 technical requirements defined by the Stanca Act. A sample of 976 web pages belonging to the websites of the Italian chief towns have been downloaded in the period October–December 2012. Such a data collection has been submitted to Achecker, the worldwide recognized syntax and accessibility validation service. Several accessibility and syntax errors have been found following the automatic analysis. Such errors have been classified, a statistic has been produced, and some graphs are included to offer an immediate view of the error distribution. Moreover, the most frequent errors are pointed out and explained in detail. Although the Stanca Act has been promulgated some years ago, and contains precise indications about updating a web page to be compliant to the 22 technical requirements, all the analyzed websites are not fully compliant to the law. Updating web pages to be compliant to the Stanca Act is a slow process and some grave errors are still present, both in terms of syntax and accessibility