Dynamin GTPase activity increases when it oligomerizes either into helices in the presence of lipid templates or into rings in the presence of SH3 domain proteins. Dynasore is a dynamin inhibitor of moderate potency (IC50 ˜ 15 μM in vitro). We show that dynasore binds stoichiometrically to detergents used for in vitro drug screening, drastically reducing its potency (IC50 = 479 μM) and research tool utility. We synthesized a focused set of dihydroxyl and trihydroxyl dynasore analogs called the Dyngo™ compounds, five of which had improved potency, reduced detergent binding and reduced cytotoxicity, conferred by changes in the position and/or number of hydroxyl substituents. The Dyngo compound 4a was the most potent compound, exhibiting a 37‐fold improvement in potency over dynasore for liposome‐stimulated helical dynamin activity. In contrast, while dynasore about equally inhibited dynamin assembled in its helical or ring states, 4a and 6a exhibited >36‐fold reduced activity against rings, suggesting that they can discriminate between helical or ring oligomerization states. 4a and 6a inhibited dynamin‐dependent endocytosis of transferrin in multiple cell types (IC50 of 5.7 and 5.8 μM, respectively), at least sixfold more potently than dynasore, but had no effect on dynamin‐independent endocytosis of cholera toxin. 4a also reduced synaptic vesicle endocytosis and activity‐dependent bulk endocytosis in cultured neurons and synaptosomes. Overall, 4a and 6a are improved and versatile helical dynamin and endocytosis inhibitors in terms of potency, non‐specific binding and cytotoxicity. The data further suggest that the ring oligomerization state of dynamin is not required for clathrin‐mediated endocytosis.

Dynamin is required for clathrin-mediated endocytosis (CME). Its GTPase activity is stimulated by phospholipid binding to its PH domain, which induces helical oligomerization. We have designed a series of novel pyrimidine-based "Pyrimidyn" compounds that inhibit the lipid-stimulated GTPase activity of full length dynamin I and II with similar potency. The most potent analogue, Pyrimidyn 7, has an IC50 of 1.1 μM for dynamin I and 1.8 μM for dynamin II, making it among the most potent dynamin inhibitors identified to date. We investigated the mechanism of action of the Pyrimidyn compounds in detail by examining the kinetics of Pyrimidyn 7 inhibition of dynamin. The compound competitively inhibits both GTP and phospholipid interactions with dynamin I. While both mechanisms of action have been previously observed separately, this is the first inhibitor series to incorporate both and thereby to target two distinct domains of dynamin. Pyrimidyn 6 and 7 reversibly inhibit CME of both transferrin and EGF in a number of non-neuronal cell lines as well as inhibiting synaptic vesicle endocytosis (SVE) in nerve terminals. Therefore, Pyrimidyn compounds block endocytosis by directly competing with GTP and lipid binding to dynamin, limiting both the recruitment of dynamin to membranes and its activation. This dual mode of action provides an important new tool for molecular dissection of dynamin's role in endocytosis.

Dynamin is a large GTPase with roles in membrane fission during clathrin-mediated endocytosis, in actin dynamics and in cytokinesis. Defects in dynamin have been linked to human diseases. The synthesis of a dynamin modulator toolkit comprising two different inhibitor classes is described. The first series comprises Dynole 34-2, Dynole 2-24 and the inactive control Dynole 31-2. The Dynole compounds act on the dynamin G domain, are not GTP competitive and can be synthesized in 2-3 d. Knoevenagel condensation of 1-(3-(dimethylamino)propyl)-1H-indole-3-carbaldehyde (1) with cyanoamides (2 and 3) affords Dynole 31-2 and Dynole 34-2, respectively. Reductive amination of 1 with decylamine gives Dynole 2-24. The second series acts at an allosteric site in the G domain of dynamin and comprises Dyngo 4a and Dyngo Ø (inactive control). Both are synthesized in an overnight reaction via condensation of 3-hydroxy-2-naphthoic hydrazide with 2,4,5-trihydroxybenzaldehyde to afford Dyngo 4a, or with benzaldehyde to afford Dyngo Ø.

Drugs that inhibit DNA topoisomerase I and DNA topoisomerase II have been widely used in cancer chemotherapy. We report herein the results of a focused medicinal chemistry effort around novel ellipticinium salts which target topoisomerase I and II enzymes with improved solubility. The salts were prepared by reaction of ellipticine with the required alkyl halide and evaluated for DNA intercalation, topoisomerase inhibition and growth inhibition against 12 cancer cell lines. Results from the topoisomerase I relaxation assay indicated that all novel ellipticine derivatives behaved as intercalating agents. At a concentration of 100 μM, specific topoisomerase I inhibition was not observed. Two of the derivatives under investigation were found to fully inhibit the DNA decatenation reaction at a concentration of 100 μM, indicative of topoisomerase II inhibition. N-Alkylation of ellipticine was found to enhance the observed growth inhibition across all cell lines and induce growth inhibition comparable to that of Irinotecan (CPT-11; GI(50) 1-18 μM) and in some cell lines better than Etoposide (VP-16; GI(50) = 0.04-5.2 μM). 6-Methylellipticine was the most potent growth inhibitory compound assessed (GI(50) = 0.47-0.9 μM). N-Alkylation of 6-methylellipticine was found to reduce this response with GI(50) values in the range of 1.3-28 μM.

This protocol describes the synthesis of two classes of clathrin inhibitors, Pitstop 1 and Pitstop 2, along with two inactive analogs that can be used as negative controls (Pitstop inactive controls, Pitnot-2 and Pitnot-2-100). Pitstop-induced inhibition of clathrin TD function acutely interferes with clathrin-mediated endocytosis (CME), synaptic vesicle recycling and cellular entry of HIV, whereas clathrin-independent internalization pathways and secretory traffic proceed unperturbed; these reagents can, therefore, be used to investigate clathrin function, and they have potential pharmacological applications. Pitstop 1 is synthesized in two steps: sulfonation of 1,8-naphthalic anhydride and subsequent reaction with 4-amino(methyl)aniline. Pitnot-1 results from the reaction of 4-amino(methyl)aniline with commercially available 4-sulfo-1,8-naphthalic anhydride potassium salt. Reaction of 1-naphthalene sulfonyl chloride with pseudothiohydantoin followed by condensation with 4-bromobenzaldehyde yields Pitstop 2. The synthesis of the inactive control commences with the condensation of 4-bromobenzaldehyde with the rhodanine core. Thioketone methylation and displacement with 1-napthylamine affords the target compound. Although Pitstop 1-series compounds are not cell permeable, they can be used in biochemical assays or be introduced into cells via microinjection. The Pitstop 2-series compounds are cell permeable. The synthesis of these compounds does not require specialist equipment and can be completed in 3-4 d. Microwave irradiation can be used to reduce the synthesis time. The synthesis of the Pitstop 2 family is easily adaptable to enable the synthesis of related compounds such as Pitstop 2-100 and Pitnot-2-100. The procedures are also simple, efficient and amenable to scale-up, enabling cost-effective in-house synthesis for users of these inhibitor classes.