The current development of the isogeometric approach in various fields of mechanics is explained by the high-accuracy results which can be achieved at a reduced computational cost by codes based on non-uniform rational B-splines (NURBS). In the case of strongly curved beams the simple diagonal de Saint-Venant’s constitutive model can lead to significant errors as it has been reported in the classic literature. Other models such as Winkler’s have been proposed and seem more suitable for these kinds of structures. Unfortunately several numerical codes are based on a diagonal constitutive model which neglects the coupling effect of elongation and curvature even if a highly refined geometry description can be developed by means of NURBS. The results obtained by means of numerical codes based on isogeometrical analysis for curved beams are here reported and basic choices, computational costs and numerical accuracy of the above-mentioned constitutive models are discussed, from a qualitative and quantitative point of view. This comparison, in the authors’ opinion, is necessary to avoid an excessive gap between the computational efficiency of NURBS, which are capable of very accurate geometry description, and a simplistic representation of the constitutive relations that is efficient for straight beams but not so much for curved beams whose curvature is large. The results of some selected tests are presented and discussed to highlight differences between the two approaches, showing that the small increase of computational cost of Winkler’s model is well compensated by the accuracy gain

The problem of free vibrations of the Timoshenko beam model is here addressed. A careful analysis of the governing equations allows identifying that the vibration spectrum consists of two parts, separated by a transition frequency, which, depending on the applied boundary conditions, might be itself part of the spectrum. For both parts of the spectrum, the values of natural frequencies are computed and the expressions of eigenmodes are provided. This allows to acknowledge that the nature of vibration modes changes when moving across the transition frequency. Among all possible combination of end constraints which can be applied to single-span beams, the case of a simply supported beam is considered. These theoretical results can be used as benchmarks for assessing the correctness of the numerical values provided by several numerical techniques, e.g. traditional Lagrangian-based finite element models or the newly developed isogeometric approach

The theoretical results relevant to the vibration modes of Timoshenko beams are here used as benchmarks for assessing the correctness of the numerical values provided by several finite element models, based on either the traditional Lagrangian interpolation or on the recently developed isogeometric approach. Comparison of results is performed on both spectrum error (in terms of the detected natural frequencies) and on the l2 relative error (in terms of the computed eigenmodes): this double check allows detecting for each finite element model, and for a discretization based on the same number of degrees‐of‐freedom, N, the frequency threshold above which some prescribed accuracy level is lost, and results become more and more unreliable. Hence a quantitative way of measuring the finite element performance in modeling a Timoshenko beam is proposed. The use of Fast Fourier Transform is finally employed, for a selected set of vibration modes, to explain the reasons of the accuracy decay, mostly linked to a poor separation of the natural frequencies in the spectrum, which is responsible of some aliasing of modes.

In order to assess decay in the mechanical characteristics of fire-exposed Reinforced Concrete (RC)