Detection of SARS-CoV-2 in sewage has been employed by several researchers as an alternative early warning indicator of virus spreading in communities, covering both symptomatic and asymptomatic cases. A factor that can seriously mislead the quantitative measurement of viral copies in sewage is the adsorption of virus fragments onto the highly porous solids suspended in wastewater, making them inaccessible. This depends not only on the available amount of suspended solids, but also on the amount of other dissolved chemicals which may influence the capacity of adsorption. On this account, the present work develops a mathematical framework, at various degrees of spatial complexity, of a physicochemical model that rationalizes the quantitative measurements of total virus fragments in sewage as regards the adsorption of virus onto suspended solids and the effect of dissolved chemicals on it. The city of Thessaloniki in Greece is employed as a convenient case study to determine the values of model variables. The present data indicate the ratio of the specific absorption (UV 254 /DOC) over the dissolved oxygen (DO) as the parameter with the highest correlation with viral copies. This implies a strong effect on viral inaccessibility in sewage caused (i) by the presence of humic-like substances and (ii) by virus decay due to oxidation and metabolic activity of bacteria. The present results suggest days where many fold corrections in the measurement of viral copies should be applied. As a result, although the detected RNA load in June 2020 is similar to that in April 2020, virus shedding in the city is about 5 times lower in June than in April, in line with the very low SARS-CoV-2 incidence and hospital admissions for COVID-19 in Thessaloniki in June.

Processing of the produced primary and secondary sludge during sewage treatment is demanding and requires considerable resources. Most common practices suggest the cotreatment of primary and secondary sludge starting with thickening and anaerobic digestion. The aim of this study is to investigate the anaerobic digestion of the primary sludge only and estimate its impact on sludge treatment and energy recovery. Within this context, the performance of the anaerobic digestion of primary sludge is explored and focused on practices to further enhance the methane production by using additives, e.g., a cationic polyelectrolyte and attapulgite. The results showed that the overall yield in methane production during anaerobic digestion of primary sludge alone was higher than that obtained by the anaerobic digestion of mixed primary and secondary sludge (up to 40%), while the addition of both organic polyelectrolyte and attapulgite enhanced further the production of methane (up to 170%). Attapulgite increased the hydrolysis rate of biosolids and produced relatively stabilized digestate, though of lower dewaterability. Moreover, the results suggest that single digestion of primary sludge may accomplish higher methane production capacities at lower digestors’ volume increasing their overall efficiency and productivity, while the produced digestates are of adequate quality for further utilization mainly in agricultural or energy sectors.