Abstract-The use of techniques such as envelope tracking (ET) and envelope elimination and restoration (EER) can improve the efficiency of radio frequency power amplifiers (RFPA). In both cases, high-bandwidth DC/DC converters called envelope amplifiers (EA) are used to modulate the supply voltage of the RFPA. This paper addresses the analysis and design of a modified two-phase Buck converter optimized to operate as EA. The effects of multiphase operation on the tracking capabilities are analyzed. The use of a fourth-order output filter is proposed to increase the attenuation of the harmonics generated by the PWM operation, thus allowing a reduction of the ratio between the switching frequency and the converter bandwidth. The design of the output filter is addressed considering envelope tracking accuracy and distortion caused by the side bands arising from the nonlinear modulation process. Finally, the proposed analysis and design methods are supported by simulation results, as well as demonstrated by experiments obtained using two 100-W, 10-MHz, two-phase Buck EAs capable of accurately tracking a 1.5-MHz bandwidth OFDM signal.

No abstract

No abstract

Power millimetre‐wave band transmitters are commonly formed by a chain of MESFET or HEMT GaAs MMIC power amplifiers. Under large‐signal conditions the reverse gate output current, which appears at the gate port of those devices due to drain‐gate breakdown mechanisms, causes a drop in the power amplifier's power added efficiency (PAE) figure, thus affecting the entire transmitter reliability. Additionally, it is desirable to obtain a stable performance from the transmitters for different ambient temperatures. In particular, millimetre‐wave wireless systems, such as the local multipoint distribution system (LMDS), require constant small signal gain for a wide range of temperatures. In this paper, an active bias network is used to compensate for both effects. The performance of the active bias network is shown to be superior, in terms of the power amplifier's PAE and the compensation of the power amplifier's small signal gain drifts due to temperature, to a conventional resistive divider when used for biasing the power amplifier. © 2003 Wiley Periodicals, Inc. Microwave Opt Technol Lett 38: 389–392, 2003; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.11069

No abstract