No abstract

No abstract

No abstract

EUV mask blanks consist of two thin film systems deposited on low thermal expansion 6 inch substrates (LTEM). First there is the multilayer stack with around 100 alternating layers of elements with different optical properties which are topped by a capping layer. The absorber stack which consists of a buffer and a absorber layer is next. Here a minimum absorption of EUV light of 99 % is required. The stress in both layer systems should be as low as possible. The reduction of defects to an absolute minimum is one of the main challenges. The high-reflective Mo/Si multilayer coatings were designed for normal incidence reflectivity and successfully deposited on 6-inch LTEM substrates by ion-beam sputtering. X-ray scattering, transmission electron microscopy and atomic force microscopy were used for characterization of the multilayer interfaces and the surface morphology. The results are correlated to the measured normal incidence reflectivity using synchrotron radiation at the "Physikalisch- Technischen Bundesanstalt" (PTB) reflectometer at BESSY II, Berlin, Germany. A high resolution laser scanner was used to measure the particle distribution. First multilayer defect results are presented

EUV Lithography requires high end quality defect free layers from the backside coating to the absorber stack. Low thermal expansion materials (LTEM) substrates with super flat surfaces are already available with low defect backside coating for E-Chuck technology. The multilayer stack is well developed from a physical point of view and major effort relies nowadays on the layer defectivity. On the other hand, absorber stack becomes one of the main challenges in terms of stress, optical behavior for ultraviolet wavelengths and dry etching behavior.Schott Lithotec is currently developing absorber stack solutions that will fulfill the requirements of next generation lithographies. There are several options for achieving the mechanical, optical and chemical specs for buffer layers and absorber coatings. Some of them are already integrated in our production processes. Buffer layers were evaluated and reach almost the physical and chemical level necessary to fit with the mask processing. TaN based absorber coatings were designed and deposited by an ion beam sputter tool optimized for low defect deposition (LDD-IBS). The chemical composition of our layer and its manufacturing process is already optimized to achieve high quality etching behavior. The current results of defect density for the absorber stack will be presented.