No abstract

No abstract

Though the solar photovoltaic (PV) module is used for power production, it usually works at high temperatures, decreasing its efficiency and therefore its output. So if an effective cooling method is to be implemented, it would reduce the heat from the solar PV module and increase its power production. Significant research in water cooling on both top and bottom surfaces of the PV module widen the scope for uniform cooling with constant module temperature throughout at any instant. In this work, uniform flow is maintained by means of overflow water from a tank fitted on the top of the PV module. Experiments were carried out with and without cooling. Performance parameters in terms of power output and efficiency have been presented for the PV module without cooling and cooling with three different mass flow rates. The results show that there is a significant rise in efficiency of the PV module by reducing its temperature. An accelerated output power of 23 W has been observed for a higher mass flow rate of 5.3 kg/min which is 15% higher than the photovoltaic module operating without cooling. Results were compared with previous researchers’ work and found to be a good enhancement. Theoretical results agree well with experiments.

Microchannel heat sinks constitute an innovative cooling technology for the removal of a large amount of heat from a small area and are suitable for electronics cooling. In the present work, Tool Steel D2 grade milling slitting saw type plain milling cutter is fabricated The microchannels are machined in aluminum work pieces to form the microchannel heat sink using the fabricated milling cutter in an horizontal milling machine. A new experimental set-up is fabricated to conduct the tests on the microchannel heat sink. The heat carried by the water increases with mass flow rate and heat input. The heat transfer coefficient and Nusselt number increases with mass flow rate and increased heat input. The pressure drop increases with Reynolds number and decreases with input heat.The friction factor decreases with Reynolds number and decreases with input heat. The thermal resistance decreases with pumping power and decreases with input heat.

No abstract