Riparian forests attenuate solar radiation, thereby mediating an important component of the thermal budget of streams. Here, we investigate the relationship between riparian degradation, stream temperature, and channel width in the Chehalis River Basin, Washington State. We used lidar data to measure canopy opening angle, the angle formed between the channel center and trees on both banks; we assumed historical tree heights and calculated the change in canopy angle relative to historical conditions. We then developed an empirical relationship between canopy angle and water temperature using existing data, and simulated temperatures between 2002 and 2080 by combining a tree growth model with climate change scenarios from the NorWeST regional prediction. The greatest change between historical and current conditions (~7°C) occurred in developed portions of the river network, with the highest values of change predicted at channel widths less than ~40 m. Tree growth lessened climate change increases in maximum temperature and the length of river exceeding biologically critical thresholds by ~50%–60%. Moreover, the maximum temperature of channels with bankfull widths less than ~50 m remained similar to current conditions, despite climate change increases. Our findings are consistent with a possible role for the riparian landscape in explaining the low sensitivity of stream temperatures to air temperatures observed in some small mountain streams.

Stream temperatures in the Pacific Northwest are projected to increase with climate change, placing additional stress on cold-water salmonids. We modeled the potential impact of increased stream temperatures on four anadromous salmonid populations in the Chehalis River Basin (spring-run and fall-run Chinook salmon Oncorhynchus tshawytscha, coho salmon O. kisutch, and steelhead O. mykiss), as well as the potential for floodplain reconnection and stream shade restoration to offset the effects of future temperature increases. In the Chehalis River Basin, peak summer stream temperatures are predicted to increase by as much as 3°C by late-century, but restoration actions can locally decrease temperatures by as much as 6°C. On average, however, basin-wide average stream temperatures are expected to increase because most reaches have low temperature reduction potential for either restoration action relative to climate change. Results from the life cycle models indicated that, without restoration actions, increased summer temperatures are likely to produce significant declines in spawner abundance by late-century for coho (-29%), steelhead (-34%), and spring-run Chinook salmon (-95%), and smaller decreases for fall-run Chinook salmon (-17%). Restoration actions reduced these declines in all cases, although model results suggest that temperature restoration alone may not fully mitigate effects of future temperature increases. Notably, floodplain reconnection provided a greater benefit than riparian restoration for steelhead and both Chinook salmon populations, but riparian restoration provided a greater benefit for coho. This pattern emerged because coho salmon tend to spawn and rear in smaller streams where shade restoration has a larger effect on stream temperature, whereas Chinook and steelhead tend to occupy larger rivers where temperatures are more influenced by floodplain connectivity. Spring-run Chinook salmon are the only population for which peak temperatures affect adult prespawn survival in addition to rearing survival, making them the most sensitive species to increasing stream temperatures.

The 12-6 Ma Hualapai Limestone was deposited in a series of basins that lie in the path of the Colorado River directly west of the Colorado Plateau and has been deformed by an en-echelon normal fault pair (Wheeler and Lost Basin Range faults). Therefore, this rock unit represents an opportunity to study the sedimentological and structural setting over which the Colorado River fi rst fl owed after integration through western Grand Canyon and Lake Mead. In this study, we quantify the structural geometry of the Hualapai Limestone and separate the deformation into syn-and postdepositional episodes. Both the Wheeler and Lost Basin Range faults were active during Hualapai Limestone deposition, as shown by thickening of strata and fanning of time lines toward half-graben faults that bound the Hualapai subbasins. The structure is characterized by a prominent reverse-drag fold and broad, shallow syncline adjacent to the Lost Basin Range fault, and a small-magnitude reverse-drag fold and short-wavelength normal-drag fold adjacent to the Wheeler fault. We fi nd ~450 m of throw between the footwall and hangingwall Hualapai Limestone sections, suggesting faulting was ongoing after Hualapai Limestone deposition ceased and during Colorado River incision. To investigate a range of possible fault geometries that may have been responsible for Hualapai Limestone deformation, we compared our structural results against surface defl ections calculated by a two-dimensional (2-D) geomechanical model. While nonunique, our results are consistent with a scenario in which the Wheeler fault was surface rupturing, or nearly surface rupturing throughout deposition of the Hualapai Limestone, but was inundated at ca. 6 Ma by coalescing paleolakes in Gregg and Grand Wash Basins as sedimentation kept pace with deformation. In contrast, we fi nd evidence suggesting the Lost Basin Range fault was deeply buried by the Hualapai Limestone and likely propagated upward and laterally to break the surface sometime after 6 Ma. Therefore, we interpret the landscape over which the Colorado River fi rst fl owed to be of low relief within the terrain bounded by the Grand Wash Cliffs, the Hiller Mountains, and subtle topographic highs to the north and south of our fi eld area. This original low-relief depositional surface was defl ected into the structure exposed today by continuing deformation by the Wheeler and Lost Basin Range faults, allowing for calculation of apparent incision rates of the modern Colorado River drainage system that spatially vary between 33 and 42 m/m.y. in the hanging wall and between 108 and 115 m/m.y. in the footwall. Hanging-wall incision rate values are similar to, but faster than, a previously published point measurement, and footwall values are similar to measured incision rates in the western Grand Canyon, suggesting the Wheeler fault system may resolve as much as ~410 m of Colorado Plateau uplift in the last 6 m.y.

Although this information product, for the most part, is in the public domain, it also may contain copyrighted materials as noted in the text. Permission to reproduce copyrighted items must be secured from the copyright owner. Part or all of this report is presented is Portable Document Format (PDF). For best results viewing and printing PDF documents, it is recommended that you download the documents to your computer and open them with Adobe Reader. PDF documents opened from your browser may not display or print as intended. Download the latest version of Adobe Reader, free of charge.