Magnetic induction tomography (MIT) is an imaging modality focused on tracing the transmission of electrical conductivity within the body. This technique used to image electromagnetic properties of an object by using the eddy current effect. This paper explains the primary analog transceiver circuit of MIT. This is a surrogate design of the analog system in the electronic components for pattern recognition and conditioning. This MIT system operating with a single excitation signal frequency at 10MHz. The input voltage received by the receiver sensor would become the circuit input which contained information. The four stages process in the receiver circuit successfully captured the signal from the transmitter. These subsystems have their functions and can be put into effect in many ways. Therefore, the circuit was used to be reliable at agarwood samples. The approach transceiver circuit were successful and functional for MIT coil sensing. The input voltage feedback depending on the conductivity of the samples. As the dielectric properties of samples are high, the input voltage at the receiver also high. Therefore, 10MHz can use for agriculture while this range of frequency is usually used in biomedical applications. Series – parallel circuit gives a greater induction factor and therefore more induced voltage for the load of the receiver.