Asphaltenes are known to be interfacially active in many circumstances such as at toluene-water interfaces. Furthermore, the term micelle has been used to describe the primary aggregation of asphaltenes in good solvents such as toluene. Nevertheless, there has been significant uncertainty regarding the critical micelle concentration (CMC) of asphaltenes and even whether the micelle concept is appropriate for asphaltenes. To avoid semantic debates we introduce the terminology critical nanoaggregate concentration (CNAC) for asphaltenes. In this report, we investigate asphaltenes and standard surfactants using high-Q, ultrasonic spectroscopy in both aqueous and organic solvents. As expected, standard surfactants are shown to exhibit a sharp break in sonic velocity versus concentration at known CMCs. To prove our methods, we measured known surfactants with CMCs in the range from 0.010 g/L to 2.3 g/L in agreement with the literature. Using density determinations, we obtain micelle compressibilities consistent with previous literature reports. Asphaltenes are also shown to exhibit behavior similar to that of ultrasonic velocity versus concentration as standard surfactants; asphaltene CNACs in toluene occur at roughly 0.1 g/L, although the exact concentration depends on the specific (crude oil) asphaltene. Furthermore, using asphaltene solution densities, we show that asphaltene nanoaggregate compressibilities are similar to micellar compressibilities obtained with standard nonionic surfactants in toluene. These results strongly support the contention that asphaltenes in toluene can be treated roughly within the micelle framework, although asphaltenes may exhibit small levels of aggregation (dimers, etc.) below their CNAC. Furthermore, our extensive results on known surfactants agree with the literature while the asphaltene CNACs reported here are one to two orders of magnitude lower than most previously published results. (Previous work utilized the terminology "micelle" and "CMC" for asphaltenes.) We believe that the previously reported high concentrations for asphaltene CMCs do not correspond to primary aggregation; perhaps they refer to higher levels of aggregation or perhaps to a particular surface structure.

The goal of predictive science is to establish structure−function relations for a system of interest. The obvious first step is to determine the structure of the system. Predictions in asphaltene science have been greatly inhibited, because of disagreement regarding molecular weight and molecular structure. With substantial progress on both structural fronts, structure−function relationships can be explored. Here, high quality factor (high-Q) ultrasonics is used to demonstrate asphaltene nanoaggregation at ∼100 mg/L. Fluorescence quenching measurements corroborate these results. Simple concepts regarding asphaltene molecular structure can be used to understand asphaltene nanoaggregation. These relations are seen to apply for asphaltene samples of very different origin. The implications of this understanding on larger-scale asphaltene aggregation and solubility are discussed.

Silicon solar cells are approaching their theoretical efficiency limit of 29%. This limitation can be exceeded with advanced device architectures, where two or more solar cells are stacked to improve the harvesting of solar energy. In this work, we devise a tandem device with a perovskite layer conformally coated on a silicon bottom cell featuring micrometric pyramids—the industry standard—to improve its photocurrent. Using an additive in the processing sequence, we regulate the perovskite crystallization process and alleviate recombination losses occurring at the perovskite top surface interfacing the electron-selective contact [buckminsterfullerene (C 60 )]. We demonstrate a device with an active area of 1.17 square centimeters, reaching a certified power conversion efficiency of 31.25%.