Background Presence of inhibitory chemicals in lignocellulose hydrolysates is a major hurdle for production of second-generation bioethanol. Especially cheaper pre-treatment methods that ensure an economical viable production process generate high levels of these inhibitory chemicals. The effect of several of these inhibitors has been extensively studied with non-xylose-fermenting laboratory strains, in synthetic media, and usually as single inhibitors, or with inhibitor concentrations much higher than those found in lignocellulose hydrolysates. However, the relevance of individual inhibitors in inhibitor-rich lignocellulose hydrolysates has remained unclear. Results The relative importance for inhibition of ethanol fermentation by two industrial second-generation yeast strains in five lignocellulose hydrolysates, from bagasse, corn cobs and spruce, has now been investigated by spiking higher concentrations of each compound in a concentration range relevant for industrial hydrolysates. The strongest inhibition was observed with industrially relevant concentrations of furfural causing partial inhibition of both D-glucose and D-xylose consumption. Addition of 3 or 6 g/L furfural strongly reduced the ethanol titer obtained with strain MD4 in all hydrolysates evaluated, in a range of 34 to 51% and of 77 to 86%, respectively. This was followed by 5-hydroxymethylfurfural, acetic acid and formic acid, for which in general, industrially relevant concentrations caused partial inhibition of D-xylose fermentation. On the other hand, spiking with levulinic acid, 4-hydroxybenzaldehyde, 4-hydroxybenzoic acid or vanillin caused little inhibition compared to unspiked hydrolysate. The further evolved MD4 strain generally showed superior performance compared to the previously developed strain GSE16-T18. Conclusion The results highlight the importance of individual inhibitor evaluation in a medium containing a genuine mix of inhibitors as well as the ethanol that is produced by the fermentation. They also highlight the potential of increasing yeast inhibitor tolerance for improving industrial process economics.

Development of cell factories for conversion of lignocellulosic biomass hydrolysates into biofuels or bio-based chemicals faces major challenges, including the presence of inhibitory chemicals derived from biomass hydrolysis or pretreatment. Extensive screening of 2526 Saccharomyces cerevisiae strains and 17 non-conventional yeast species identified a Candida glabrata strain as the most 5-hydroxymethylfurfural (HMF) tolerant. Whole-genome (WG) transformation of the second-generation industrial S. cerevisiae strain MD4 with genomic DNA from C. glabrata, but not from non-tolerant strains, allowed selection of stable transformants in the presence of HMF. Transformant GVM0 showed the highest HMF tolerance for growth on plates and in small-scale fermentations. Comparison of the WG sequence of MD4 and GVM1, a diploid segregant of GVM0 with similarly high HMF tolerance, surprisingly revealed only nine non-synonymous SNPs, of which none were present in the C. glabrata genome. Reciprocal hemizygosity analysis in diploid strain GVM1 revealed AST2N406I as the only causative mutation. This novel SNP improved tolerance to HMF, furfural and other inhibitors, when introduced in different yeast genetic backgrounds and both in synthetic media and lignocellulose hydrolysates. It stimulated disappearance of HMF and furfural from the medium and enhanced in vitro furfural NADH-dependent reducing activity. The corresponding mutation present in AST1 (i.e. AST1D405I) the paralog gene of AST2, also improved inhibitor tolerance but only in combination with AST2N406I and in presence of high inhibitor concentrations. Our work provides a powerful genetic tool to improve yeast inhibitor tolerance in lignocellulosic biomass hydrolysates and other inhibitor-rich industrial media, and it has revealed for the first time a clear function for Ast2 and Ast1 in inhibitor tolerance.

Terminally differentiated cells are regarded as the most stable and common cell state in adult organisms as they reside in growth arrest and carry out their cellular function. Improving our understanding of the mechanisms involved in promoting cell cycle exit would facilitate our ability to manipulate pluripotent cells into mature tissues for both pharmacological and therapeutic use. Here, we demonstrated that a hyperosmolar environment enforced a protective p53-independent quiescent state in dedifferentiated hepatoma cells and pluripotent stem cells (PSCs)-derived models of human hepatocytes and endothelial cells, representing the endodermal and mesodermal lineages. Prolonged culture in hyperosmolar conditions stimulated transcriptional and functional cell maturation. Interestingly, hyperosmolar conditions did not only trigger cell cycle exit and cellular maturation but were also necessary to maintain this maturated state, as switching back to plasma osmolarity caused the loss of maturation markers and the gain of proliferative markers. Transcriptome analysis revealed activation of NF-κB and repression of WNT signaling as the two main pathways downstream of osmolarity-regulated growth arrest and cell maturation, respectively. This study revealed that increased osmolarity serves as a biochemical signal to promote long-term growth arrest, transcriptional changes, and maturation into different lineages, serving as a practical method to generate differentiated hiPSCs that resemble their mature counterpart more closely.