Stress-ribbon systems develop the most flexible and slender bridges. A structural system of such elegant bridges consists of cables or ribbons and deck slabs placed to these strips to distribute the live load. Although this structural system is simple, the design of such structures is a challenging issue. Design limitations of the bridge deck slope induce considerable forces in the ribbons, which transfer the tension to massive foundations. The deformation increase under concentrated and asymmetrical loads causes another problem of stress-ribbon bridges—the kinematic component, the design object of such structures, exceeds the dead load-induced vertical displacement several times. This paper introduces a new concept of such a structural system, comprising ribbons made of flexural-stiff profiles. The proposed approach to reduce kinematic displacements is illustrated experimentally by testing two pedestrian bridge prototypes with different flexural stiffness of the steel ribbons. Numerical models calibrated using the test results are used for the parametric analysis of the flexural stiffness effect on the deformation behaviour of the bridge system with steel and fibre-reinforced polymer (FRP) ribbons. A practical approach to the choice of the efficient flexural stiffness of the ribbon-profiles is also proposed.
Recently, two-span, or the so-called single pylon suspension bridges, due to their constructing structure, have been widely applied. A reduction in deformation seems to be the main problem of the behaviour and design of such bridges. The deformation of suspension bridges is mainly determined by cable kinematic displacements caused by temporary loadings rather than by elastic deformations. Not all known methods for the stabilization of the initial form of suspension bridges are suitable for single pylon bridges. The employment of the so-called rigid cables that increase the general stiffness of the suspension bridge appears to be one of the innovative methods for stabilizing the initial form of single pylon suspension bridges. Rigid cables are designed from standard steel profiles and, compared to the common ones made of spiral and parallel wires, are more resistant to corrosion. Moreover, the construction joints, in terms of fabrication and installation, have a simpler form. However, calculation methods for such single pylon suspension bridges with rigid cables are not sufficiently prepared. Only single publications on the analysis of the behaviour of one or three-span suspension bridges with rigid cables have been available so far. The paper presents analytical expressions to calculate the displacements and internal forces of suspension bridges with rigid cables thus assessing the sequence of cable installation. Also, the paper describes the sequence of iterative calculation.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.