This case study paper is about a large rotational rock and earth slide-earth flow located in the Secchia River Valley, in the Northern Apennines of Italy, that has displayed multiple reactivation phases between 2002 and 2004. The main geological constraints of the mass movement are related to the overlap of flysch rock masses over clayey complexes that allows rock slides to take place in the source area. The disarrangement and weathering of rock masses following slope movements causes large amount of fine-grained debris to be accumulated on the slope and mobilised by earth sliding and flowing. Analysis of rainfall data at the onset of reactivation events has proved that they occurred after periods with cumulated values higher than the averages of the last 30 years. The quantification of the morphological modifications induced by these reactivations has been made possible by comparing pre- and post-event digital elevation models. Depletion and accumulation has been in the range Of 30 m in different parts of the slope. In particular, an advancement of the landslide toe of more than 400 m, which caused a 30-m thick landslide tip to deposit, has been clearly seen. Monitoring data regarding subsurface movements and surface tension crack widening (tension cracks so large as to be properly described at trenches) has shown that sliding surfaces as deep as 43 m exist in the upper part of the landslide, while the accumulation lobe has moved by sliding and flowing over surfaces as deep as some 10 m. Velocities of cm/day have been recorded in the deep surfaces and in widening trenches of the source area, while the advancement of the accumulation lobe has been estimated as having velocities of up to 10 m/day. Groundwater in the landslide body has been observed at depths of 5-15 m in the upper areas, while it is estimated as being at the ground level in the toe. On this basis, it is concluded that the landslide still has a high potential for further development, both in the upper landslide zone and in the toe area

No abstract

Abstract. The Ca' Lita landslide is a large and deep-seated mass movement located in the Secchia River Valley, in the sector of the Northern Apennines falling into Reggio Emilia Province, about 70 km west of Bologna (Northern Italy). It consists of a composite landslide system that affects Cretaceous to Eocene flysch rock masses and chaotic complexes. This paper presents the analysis and the quantification of displacement rates and depths of the mass movements, based on geological and geomorphological surveys, differential DEM analysis, interpretation of underground stratigraphic and monitoring data collected during the investigation campaign that has been undertaken in order to design cost-effective mitigation structures, and that has been conducted with the joint collaboration between public offices and research institutes.

An automated total station monitored a compound rock slide near the Cerreto Pass (northern Apennines, Italy) for more than three and a half years. The rock slide, which threatens national road SS63, has an estimated volume of more than 3 million m3 and is composed by the overlap of highly fractured limestone on an impermeable and weak clay shale layer. Specifically, a network of more than 30 prisms has been measured every 2 h from October 2009 to May 2013. This dataset provides substantial evidence of displacement rates up to 15 cm/year and gives information about the control of rainfall on slope movements. On the yearly scale the seasonal variation of rainfall regime determines the baseline displacement rate of the rockslide while moving to shorter time spans has been possible to individuate effects of rain episodes calculated on daily and weekly sampling. Results highlight the added value of continuous monitoring for assessing rock slide dynamics and improving hazard assessment

In the evening of February 28, 2004, a landslide took place in the village of Rossena (Northern Apennines, Italy), built at the base of a crag shaped in a basalt mass and wrapped in highly deformed formation of clay and shale with blocks. The failure damaged some houses, roads and fields but, fortunately, the medieval Rossena Castle, lying on the crag, was not involved at all. The goal of the study was to attain a technical and geological model of the slope to generate a landslide risk zonation, for regularity and development planning, so that the most correct action plans could be proposed. A detailed geological and geomorphological survey allowed for distinguishing the different gravitative landform of this area. It was very helpful to plan direct and indirect investigation, including borehole drillings, samplings, seismic (tomography), and electrical surveys. A monitoring system was built up immediately after the event (three wire extensometers and one inclinometer), then progressively substituted by a more complete one (two tiltmeters, two jointmeters, four inclinometers, two incremental extensometers, and two piezometers). The phenomenon can be divided in different parts. The central sector of the slope is interested by compound slides likely affecting the bedrock and can be considered, at present, the 'engine' of the whole instability framework. Indeed, as a consequence, in the upper portion of the slope the huge blocks in which the outer part of the crag is disjointed experienced vertical displacements and, locally, topplings. Finally, the lowest sector is affected by slow movements, probably connected to bedrock creep or rock flow, while the toe, really at the foot of the slope, by shallow landslides. This instability framework is the result of a complex evolution, starting almost more than 9,000 years ago, as testified from a radiocarbon dating. In more recent time (19th century), the Rossena landslide was also triggered by an earthquake that induced the partially breaking up of the crag, causing rock falls and cracks in the ground.