Our civilization relies on synthetic polymers for all aspects of modern life; yet, inefficient recycling and extremely slow environmental degradation of plastics are causing increasing concern about their widespread use. After a single use, many of these materials are currently treated as waste, underutilizing their inherent chemical and energy value. In this study, energy-rich polyethylene (PE) macromolecules are catalytically transformed into value-added products by hydrogenolysis using well-dispersed Pt nanoparticles (NPs) supported on SrTiO3 perovskite nanocuboids by atomic layer deposition. Pt/SrTiO3 completely converts PE (Mn = 8000–158,000 Da) or a single-use plastic bag (Mn = 31,000 Da) into high-quality liquid products, such as lubricants and waxes, characterized by a narrow distribution of oligomeric chains, at 170 psi H2 and 300 °C under solvent-free conditions for reaction durations up to 96 h. The binding of PE onto the catalyst surface contributes to the number averaged molecular weight (Mn) and the narrow polydispersity (Đ) of the final liquid product. Solid-state nuclear magnetic resonance of 13C-enriched PE adsorption studies and density functional theory computations suggest that PE adsorption is more favorable on Pt sites than that on the SrTiO3 support. Smaller Pt NPs with higher concentrations of undercoordinated Pt sites over-hydrogenolyzed PE to undesired light hydrocarbons.

To probe the active sites of nitrogen-doped carbon nanostructures (CN x ), the effect of dihydrogen phosphate (H2PO4 –) anion on their oxygen reduction reaction (ORR) performance was investigated by adding increasing concentrations of phosphoric acid in half-cell measurements. A linear decrease in specific kinetic current at 0.7 V was noted with increasing phosphate anion concentration. It was also found that the adsorption of phosphate species on CN x was strong and the corresponding ORR activity was not recovered when the catalyst was reintroduced to a fresh HClO4 solution. Trends similar to those noted upon addition of H3PO4 to the half-cell were observed when CN x catalysts were soaked in phosphoric acid. Adsorption of dihydrogen phosphate ions on the surface of CN x exposed to phosphoric acid was verified by transmission infrared (IR) and Raman spectroscopy as well as X-ray photoelectron spectroscopy (XPS). XPS results also showed a decrease in the surface concentration of pyridinic-N species accompanied by an increase of equal magnitude in the surface fraction of quaternary-N species, which would include the pyridinic-NH sites. A linear correlation was observed between the loss in pyridinic-N site density and that in ORR activity. The observed poisoning phenomenon is consistent with the two possible active site models, i.e., pyridinic-N sites, which would be rendered inactive by protonation, or the C sites neighboring pyridinic-N species. These latter species would be poisoned by a site blocking effect if they strongly adsorb the phosphate ions. Strong adsorption of negatively charged phosphate ions on neighboring C atoms would also stabilize the pyridinic-NH sites. By identifying a poison that can be used as a probe, this study provides a first step toward identification and quantification of active sites in CN x catalysts.

The development of on-purpose 1,3-butadiene (BDE) technologies remains an active area in catalysis research, because of the importance of BDE in industrial polymer production. Here, we report on a nonoxidative dehydrogenation catalyst for the production of BDE prepared by atomically precise installation of platinum sites on a Zn-modified SiO 2 support via atomic layer deposition (ALD). In situ reduction X-ray absorption spectroscopy (XAS), X-ray photoelectron spectroscopy (XPS), CO chemisorption, and high-angle annular dark-field (HAADF) scanning transmission electron microscopy (STEM) imaging of activated PtZn/SiO 2 , revealed the formation of a uniform, well-distributed subnanometer-to nanometer-sized PtZn (1.2 ± 0.3 nm) alloy as the active catalytic species.

Serum VEGF level is significantly associated with the clinical staging of the patients (operable and inoperable) (P = 0.031) and it also correlates with the prognosis of the patients (P = 0.0006).

Understanding the mechanisms of action for base metal catalysis of transformations typically associated with precious metals is essential for the design of technologies for a sustainable energy economy. Isolated transitionmetal and post-transition-metal catalysts on oxides such as silica are generally proposed to effect hydrogenation and dehydrogenation by a mechanism featuring either σ-bond metathesis or heterolytic bond cleavage as the key bond activation step. In this work, an organovanadium(III) complex on silica, which is a precatalyst for both olefin hydrogenation and alkane dehydrogenation, is interrogated by a series of reaction kinetics and isotopic labeling studies in order to shed light on the operant mechanism for hydrogenation. The kinetic dependencies of the reaction components are potentially consistent with both the σ-bond metathesis and the heterolytic bond activation mechanisms; however, a key deuterium incorporation experiment definitively excludes the simple σ-bond metathesis mechanism. Alternatively, a twoelectron redox cycle, rarely invoked for homologous catalyst systems, is also consistent with experimental observations. Evidence supporting the formation of a persistent vanadium(III) hydride upon hydrogen treatment of the as-prepared material is also presented.