Niobium-alumina aggregate fractions with particle sizes up to 3150 µm were produced by crushing pre-synthesised fine-grained composites. Phase separation with niobium enrichment in the aggregate class 45–500 µm was revealed by XRD/Rietveld analysis. To reduce the amount of carbon-based impurities, no organic additives were used for the castable mixtures, which resulted in water demands of approximately 27 vol.% for the fine- and coarse-grained castables. As a consequence, open porosities of 18% and 30% were determined for the fine- and coarse-grained composites, respectively. Due to increased porosity, the modulus of rupture at room temperature decreased from 52 MPa for the fine-grained composite to 11 MPa for the coarse-grained one. However, even the compressive yield strength decreased from 49 MPa to 18 MPa at 1300 °C for the fine-grained to the coarse-grained composite, the latter showed still plasticity with a strain up to 5%. The electrical conductivity of fine-grained composite samples was in the range between 40 and 60 S/cm, which is fifteen magnitudes above the values of pure corundum.

The development of coarse‐grained refractory composites combining refractory ceramics with refractory metals provides new approaches for high‐temperature applications. In particular, coarse‐grained Nb‐Al2O3 composites are widely interested due to their promising functional properties such as high thermal shock resistance, low shrinkage and good electrical conductivity. In order to identify and release the potential of these materials in advanced applications, their mechanical behavior should be evaluated. This study presents room‐ and high‐temperature compression behavior up to 1500 °C of Nb‐Al2O3 refractory composites manufactured via castable and extrusion technology. The influences of production method, particle size, open porosity as well as temperature and strain rate are discussed. For comparison, pure niobium and alumina specimens are used as reference materials. The results indicate that Nb‐Al2O3 refractory composites show high ductility at high temperatures. This behavior is also verified with microstructural investigations by scanning electron microscope (SEM).

Niobium‐alumina composite aggregates with 60 vol% metal content and with particle sizes up to 3150 μm are produced using castable technology followed by sintering, and a crushing and sieving process. X‐Ray diffraction (XRD) analysis reveals phase separation during crushing as the niobium:corundum volume ratios is between 37:57 and 64:31 among the 4 produced aggregate classes 0–45, 45–500, 500–1000, and 1000–3150 μm. The synthesized aggregates are used to produce coarse‐grained refractory composites in a second casting and sintering step. The fine‐ and coarse‐grained material shows porosities between 32% and 36% with a determined cold modulus of rupture of 20 and 12 MPa, and E‐moduli of 37 and 46 GPa, respectively. The synthesized fine‐grained composites reached true strain values between 0.08 at 1100 °C and 0.18 at 1500 °C and the coarse‐grained ones values between 0.02 and 0.09. The electrical conductivity for the fine‐grained and the coarse‐grained material is 448±66 and 111±25 S cm−1, respectively.