The revised (four-step) BCR sequential extraction procedure has been applied to fractionate the chromium, copper, iron, manganese, nickel, lead and zinc contents in urban soil samples from public-access areas in five European cities. A preliminary inter-laboratory comparison was conducted and showed that data obtained by different laboratories participating in the study were sufficiently harmonious for comparisons to be made between cities and land types (e.g. parks, roadside, riverbanks, etc.). Analyte recoveries by sequential extraction, with respect to direct aqua regia digestion, were generally acceptable (100 ± 15%). Iron, nickel and, at most sites, chromium were found mainly in association with the residual phase of the soil matrix. Copper was present in the reducible, oxidisable and residual fractions, whilst zinc was found in all four sequential extracts. Manganese was strongly associated with reducible material as, in some cities, was lead. This is of concern because high lead concentrations were present in some soils (>500 mg kg−1) and the potential exists for remobilisation under reducing conditions. As would be expected, extractable metal contents were generally highest in older, more heavily industrialised cities. Copper, lead and zinc showed marked (and often correlated) variations in concentrations between sites within the same city whereas manganese and, especially, iron, did not. No overall relationships were, however, found between analyte concentrations and land use, nor between analyte partitioning and land use

Use of a harmonised sampling regime has allowed comparison of concentrations of copper, chromium, nickel, lead and zinc in six urban parks located in different European cities differing markedly in their climate and industrial history. Wide concentrations ranges were found for copper, lead and zinc at most sites, but for chromium and nickel a wide range was only seen in the Italian park, where levels were also considerably greater than in other soils. As might be expected, the soils from older cities with a legacy of heavy manufacturing industry (Glasgow, Torino) were richest in potentially toxic elements (PTEs); soils from Ljubljana, Sevilla and Uppsala had intermediate metal contents, and soils from the most recently established park, in the least industrialised city (Aveiro), displayed lowest concentrations. When principal component analysis was applied to the data, associations were revealed between pH and organic carbon content; and between all five PTEs. When pH and organic carbon content were excluded from the PCA, a distinction became clear between copper, lead and zinc (the ''urban'' metals) on the one hand, and chromium and nickel on the other. Similar results were obtained for the surface (0-10 cm depth) and sub-surface (10-20 cm depth) samples. Comparisons with target or limit concentrations were limited by the existence of different legislation in different countries and the fact that few guidelines deal specifically with public-access urban soils intended for recreational use.

No abstract

As part of a harmonised assessment of urban soils (http://www.urbsoil.paisley.ac.uk), we investigated the variability of metal content in soils from Aveiro (Portugal) and Glasgow (UK). Samples were collected from parks and other public open spaces in each city. Metal content (Al, Ca, Cr, Cu, Fe, Mn, Ni, Pb and Zn) and basic soil parameters (texture, CEC, pH, organic matter) were determined and data investigated using principal component analysis (PCA). The two cities differ in absolute levels of metal content reflecting industrial and historical development. Factors identified by PCA included anthropogenic (Cu, Pb, Zn), soil properties and geology, which explain variability when data were assessed based on metal content, soil properties and land use. This study highlights the contribution from geological background even in strongly urbanised environments

No abstract