Tris(2,3-dibromopropyl) isocyanurate (TBC) is a heterocyclic hexabrominated flame retardant, which cannot be degraded even over a long time and may be a potential environmental pollutant. In this paper, TBC is for the first time as far as we know determined by silver nitrate-enhanced electrochemiluminescence (ECL) using a gold nanoparticles (AuNPs)-modified gold electrode. In our experiments, TBC was found to have the characteristics of increasing the ECL intensity of Ru(bpy)(3)(2+), and the ECL signal was proportional to the concentration of TBC. Based on this, we have successfully developed a novel, fast and sensitive method for the analysis of TBC. The main influencing factors including the volume ratio of acetonitrile and water, and the concentration of Ru(bpy)(3)(2+) were investigated in detail. Compared with using a bare gold electrode in MeCN without AgNO(3), the limit of detection is remarkably lowered by 20 times and the linear range is expanded by 5 times by using the AuNPs-modified gold electrode and AgNO(3). Under the optimal conditions, a limit of detection of 5.0 × 10(-8) M (S/N = 3) is achieved with a linear range of 1.0 × 10(-7) to 5.0 × 10(-5) M. The mechanism of the ECL enhancement of the system is also investigated.

In this paper, we report a sensitive method for ECL detection for CE based on generation of gold nanostructures at the surface of Pt electrode by electrodeposition. Difenidol hydrochloride was used as a model analyte. With the increase of electrodeposition amount, the morphology of gold nanostructures changed from discrete nanoflowers to dense nanoparticle array. Interestingly, the variation of deposition amount also greatly affected the ECL intensity of difenidol. The ECL intensity increased remarkably with deposition amount and reached the maximum value at the deposition amount of 7.0 Â 10 À8 C; further increasing the deposition amount, however, caused the ECL intensity to decrease. Other conditions, including applied potential, injection time and voltage, buffer pH, were also optimized in detail. Under the optimized conditions, the linear response range of difenidol is from 1.0 Â 10 À8 to 5.0 Â 10 À5 M, and the detection limit was 4.0 Â 10 À9 M (S/N 5 3). The RSDs of ECL intensity and migration time were 2.0 and 1.6%, respectively (n 5 5, at 7.5 mM difenidol). Compared with using bare electrode, the detection sensitivity was significantly improved by ca. two orders of magnitude. Notably, the nanogold was prepared at the surface of electrode and no nanogold was added to the electrophoretic buffer or detection cell, thus causing no interference to the separation. Finally, the proposed method was successfully applied to the analysis of difenidol in tablets and urine samples. With high sensitivity and good reproducibility, this method provides a promising platform for the determination of pharmaceuticals that have a tertiary amine group such as difenidol. 3 -based ECL detection offers lower background noise, higher detection sensitivity and has been adopted widely for detection of various analytes [4][5][6][7][8][9]. Coupling ECL detection with CE has also been widely investigated, and a variety of methods have been developed to enhance the sensitivity of ECL detection [10][11][12]. KeywordsMetal nanoparticles have attracted much interest in analytical chemistry because of their easy preparation and relatively large surface area, size-controllability and unusual chemical properties [13][14][15]. Specifically, Pt and Au nanoparticles (Pt/AuNPs) have shown some fascinating properties in modifying electrode [16][17][18][19]. They can increase the electrode surface area, promote electron transfer and thus enhance the detection sensitivity [20,21]