Lacustrine shale oil has the potential to lead the development of China's oil and gas industry. By integrating scanning electron microscopy, low-temperature CO2 and N2 adsorption, high-pressure mercury intrusion, and nuclear magnetic resonance with centrifugation at different speeds, the pore system and pore fluid distribution of Da’anzhai Member lacustrine shale in the Sichuan Basin are studied. The results show that: (1) The reservoir space is mainly inorganic pores and micro-fractures. Nano-micron scale pores are commonly found and widely distributed in the Da’anzhai shale with multiple peaks of 28 nm, 200 nm, 900 nm, and 3.5 µm. The total pore volume ranges from 0.00849 to 0.02808 cm³/g, and the pores ranging from 100 nm to 1000 nm are the main contributors to total pore volume. (2) Pore fluid can be divided into movable oil, bound oil, and adsorption oil. The proportion of movable oil, bound oil, and adsorbed oil is 21.4%, 12.4%, and 66.2% in Da’anzhai shale, respectively. Movable oil mainly occurs in pores larger than 350 nm, bound oil is 30–350 nm, while adsorbed oil mainly exists in pores below 30 nm. (3) The higher the total organic carbon content and clay minerals content, the smaller the pore size, resulting in the low content of movable oil. The higher the content of brittle minerals such as quartz, the better the development of intergranular pores and microfractures, and the higher the content of movable oil. Through the grading evaluation of shale pore structure and pore fluid, it is conducive to guide the exploration and development of Da’anzhai shale oil, which has important theoretical and practical significance.

Deeply buried (>3500 m) marine shale has become a focus point for the future exploration and exploitation of shale hydrocarbon in China. Low-temperature nitrogen adsorption (LTNA), scanning electron microscopy (SEM), nuclear magnetic resonance (NMR), and other experiments were combined to characterize the pore structure and fluid division in deep-marine shale of the southern Sichuan Basin in this study. The results suggest that the deep-marine shale had a relatively developed nanopore network, especially with honeycomb organic pores. These organic pores were largely macropores with good connectivity in three-dimensional space and constituted the major reservoir space of the deep-marine shale gas. Microfractures were predominantly clay-mineral-related fractures, and the development degree of microfractures connected with organic pores was low, which contributed to the preservation of organic pores. Within the deep-marine shale interval, the pore volumes of Section 1 and Section 3 were higher. Pore volume was predominantly contributed by pores above 10 nm, where macropores accounted for a large proportion. Based on a combination of high-speed centrifugation and gradient temperature drying, the pore fluid of deep-marine shale reservoirs was quantitatively classified into four types: clay-bound fluid, capillary-bound fluid, free-flowing fluid, and closed-pore fluid. The clay-bound fluid existed in pores of less than 4.25 nm, which cannot be exploited. Quantitative division of the shale pore system could be realized by using the pore space differences of different types of fluids.

Based on porosity and permeability tests, high-pressure mercury injection (HPMI), nuclear magnetic resonance (NMR) and centrifugal experiments, this study comprehensively analyzed the quality, pore structure and fractal characteristics of tight sandstone reservoir in meandering stream facies. The purpose is to reveal the relationship between physical properties, geometry and topological parameters of pores, fluid mobility and heterogeneity of pore system of tight sandstone reservoirs in meandering stream facies. The results show that the second member of the Middle Jurassic Shaximiao Formation (J2S2) in the central Sichuan Basin has developed tight sandstone reservoir of meandering fluvial facies, the pore radius of type I reservoir (K>0.3 mD) is mainly distributed at 0.01 μm∼2 μm, the tortuosity ranges between 2.571 and 2.869, and the average movable fluid saturation is 70.12%. The pore radius of type II reservoir (0.08mD<K<0.3 mD) is mainly 0.003 μm∼1 μm, the tortuosity ranges between 2.401 and 3.224, the average movable fluid saturation is 57.59%. The pore radius of type III reservoir (K<0.08 mD) is mainly 0.001 μm∼0.4 μm, the tortuosity ranges between 0.905 and 2.195, and the average movable fluid saturation is 13.46%. Capillary-Paraachor point (CP point) and T2 cut-off value (T2cutoff) are used to divide the fractal interval of capillary pressure curve and T2 spectrum. The fractal dimension Dh2 of small pores calculated by HPMI through 3D capillary tube model, the fractal dimension Dn1 of large pores and Dn2 of small pores calculated by NMR through wetting phase model can effectively characterize the heterogeneity of reservoir pores. Among them, Dn1 has a strong negative correlation with porosity, permeability, pore radius and movable fluid saturation, indicating that the reservoir capacity, seepage capacity and pore size are mainly controlled by large pores, therefore, Dn1 can be used as an effective reservoir evaluation parameter.

The Lower Permian Shanxi Formation in the Eastern Ordos Basin is a set of transitional shale, and it is also a key target for shale gas exploration in China. Three sets of organic-rich transitional shale intervals (Lower shale, Middle shale and Upper shale) developed in Shan 23 Submember of Shanxi Formation. Based on TOC test, X-diffraction, porosity, in-situ gas content experiment and NMR experiments with gradient centrifugation and drying temperature, the reservoir characteristics and pore fluid distribution of the three sets of organic-rich transitional shale are studied. The results show that: 1) The Middle and Lower shales have higher TOC content, brittleness index and gas content, reflecting better reservoir quality, while the Upper shales have lower gas content and fracturing ability. The total gas content of shale in the Middle and Lower shales is high, and the lost gas and desorbed gas account for 80% of the total gas content. 2) The Middle shale has the highest movable water content (32.58%), while the Lower shale has the highest capillary bound water content (57.52%). In general, the capillary bound water content of marine-continental transitional shale in the Shan 23 Submember of the study area is high, ranging from 39.96% to 57.52%. 3) Based on pore fluid flow capacity, shale pores are divided into movable pores, bound pores and immovable pores. The Middle shale and the Lower shale have high movable pores, with the porosity ratio up to 27%, and the lower limit of exploitable pore size is 10 nm. The movable pore content of upper shale is 25%, and the lower limit of pore size is 12.6 nm. It is suggested that the Lower and Middle shales have more development potential under the associated development technology.