With the advent of pure-spin-current sources, spin-based electronic (spintronic) devices no longer require electrical charge transfer, opening new possibilities for both conducting and insulating spintronic systems. Pure spin currents have been used to suppress noise caused by thermal fluctuations in magnetic nanodevices, amplify propagating magnetization waves, and to reduce the dynamic damping in magnetic films. However, generation of coherent auto-oscillations by pure spin currents has not been achieved so far. Here we demonstrate the generation of single-mode coherent auto-oscillations in a device that combines local injection of a pure spin current with enhanced spin-wave radiation losses. Counterintuitively, radiation losses enable excitation of auto-oscillation, suppressing the nonlinear processes that prevent auto-oscillation by redistributing the energy between different modes. Our devices exhibit auto-oscillations at moderate current densities, at a microwave frequency tunable over a wide range. These findings suggest a new route for the implementation of nanoscale microwave sources for next-generation integrated electronics.

No abstract

No abstract

As a major improvement in three-dimensional (3D) atom probe, the range of applicable material classes has recently been broadened by the establishment of laser-assisted atom probes (LA-3DAP). Meanwhile, measurements of materials of low conductivity, such as dielectrics, ceramics, and semiconductors, have widely been demonstrated. However, besides different evaporation probabilities, heterogeneous dielectric properties are expected to give rise to additional artifacts in the 3D volume reconstruction on which the method is based. In this article, these conceivable artifacts are discussed based on a numeric simulation of the field evaporation. Sample tips of layer- or precipitate-type geometry are considered. It is demonstrated that dielectric materials tend to behave similarly to metals of reduced critical evaporation field.

No abstract