Regarding the problems of resonance and direct current (DC) components when the Z-source inverter (ZSI) without an isolation transformer is connected to the grid through an LCL filter, this paper proposes a novel DC component suppression strategy for a grid-connected ZSI based on the split capacitor method of disturbance observer (DOB). The split capacitor method is utilized to convert a third-order LCL filter into a first-order one to eliminate the resonance problem. The DC component of the inverter output voltage is regarded as an external disturbance, and the employed DOB is used to observe it, which is fed forward to suppress the DC disturbance component. Various comparison results of the simulation and experiment show that the proposed control strategy can effectively reduce grid-connected DC components injected into the grid at less than 0.5%, which decreases the DC component from 1.8% to 0.1%.

In response to the key engineering problems of photovoltaic grid-connected inverter cluster resonance suppression affected by grid-connected inverter impedance, in this paper, a control strategy based on a disturbance observer is proposed to dynamically compensate for the damping coefficient of the controlled system and improve the robustness of the system. First, an engineering mathematical model of a 200 MW photovoltaic inverter cluster is established, and the mechanism of the active damping of the cluster inverter influenced by the disturbance is analyzed. Secondly, the capacitor current feedback is utilized to constitute the virtual damping, and the inverter output impedance is reshaped to suppress the resonance peak. Then, a Kalman filter is used to improve the traditional disturbance observer to accurately detect disturbance of the system during the dynamic process of the cluster inverter so as to better adapt to changes in grid impedance and dynamically compensate for the virtual damping of the cluster resonant system. Finally, the proposed control strategy is verified with respect to a practical PV power station. The experimental results demonstrate the feasibility of the proposed control method.