The creation of continuous nanoscale composite fibrils from carbon nanotubes using an electrospinning process is reported. Nanotube bundles align in the fiber, and upon heat treatment, the composite fibrils are carbonized at 1100 °C to form the SWNT/carbon yarns. The fibrils show superior mechanical properties and can be used as a reinforcement for a variety of materials.

The dynamics of nonspecific and specific Escherichia coli RNA polymerase (RNAP)-DNA complexes have been directly observed using scanning force microscopy operating in buffer. To this end, imaging conditions had to be found in which DNA molecules were adsorbed onto mica strongly enough to be imaged, but loosely enough to be able to diffuse on the surface. In sequential images of nonspecific complexes, RNAP was seen to slide along DNA, performing a one-dimensional random walk. Heparin, a substance known to disrupt nonspecific RNAP-DNA interactions, prevented sliding. These observations suggest that diffusion of RNAP along DNA constitutes a mechanism for accelerated promoter location. Sequential images of single, transcribing RNAP molecules were also investigated. Upon addition of 5 microM nucleoside triphosphates to stalled elongation complexes in the liquid chamber, RNAP molecules were seen to processively thread their template at rates of 1.5 nucleotide/s in a direction consistent with the promoter orientation. Transcription assays, performed with radiolabeled, mica-bound transcription complexes, confirmed this rate, which was about three times smaller than the rate of complexes in solution. This assay also showed that the pattern of pause sites and the termination site were affected by the surface. By using the Einstein-Sutherland friction-diffusion relation the loading force experienced by RNAP due to DNA-surface friction is estimated and discussed.

Recent advances in single molecule manipulation methods offer a novel approach to investigating the protein folding problem. These studies usually are done on molecules that are naturally organized as linear arrays of globular domains. To extend these techniques to study proteins that normally exist as monomers, we have developed a method of synthesizing polymers of protein molecules in the solid state. By introducing cysteines at locations where bacteriophage T4 lysozyme molecules contact each other in a crystal and taking advantage of the alignment provided by the lattice, we have obtained polymers of defined polarity up to 25 molecules long that retain enzymatic activity. These polymers then were manipulated mechanically by using a modified scanning force microscope to characterize the force-induced reversible unfolding of the individual lysozyme molecules. This approach should be general and adaptable to many other proteins with known crystal structures. For T4 lysozyme, the force required to unfold the monomers was 64 ؎ 16 pN at the pulling speed used. Refolding occurred within 1 sec of relaxation with an efficiency close to 100%. Analysis of the force versus extension curves suggests that the mechanical unfolding transition follows a two-state model. The unfolding forces determined in 1 M guanidine hydrochloride indicate that in these conditions the activation barrier for unfolding is reduced by 2 kcal͞mol.