The Hu-12 Block, located in ZhongYuan Oilfield, Henan Province China, contains many small but highly heterogeneous oil reservoirs, with low permeability oil bearing formations and high permeability mixed (oil/water) layers. The reservoir temperature is 90 o C, and the original reservoir pressure of nearly 25 MPa, and with high salinity of formation water (around 200,000 mg/l). After 20 years of water injection, the recovery factor achieved was only 20-25%, and average water cut has reached to over 95%. N 2 gas injection has been tried with less success due to early gas breakthrough from high permeability zones. Since 2006, high pressure air foam and air injection (Air Foam Alternative Air Injection, AFAAI) has been proposed and implemented in one of the reservoirs, in order to block high permeability water zones and increase the sweeping efficiency of air and water injection. A series of laboratory experiments have been conducted to study the oxidation kinetics of air/air foam with oil and the blocking and displacement efficiency of air foams in different oil sands. Reservoir simulation has also been carried out for predicting the reservoir response to air foam injection and optimizing the injection process. Air foam and air injection was started in the field since May 2007 in a well group with 1 injector and 4 producers, using a small high pressure air compressor (40 MPa, 7 m 3 /min air rate). Up to now, 460,000 Nm 3 air and 2920 m 3 foam surfactant solution have been injected into the reservoir. The field results show that no oxygen/N 2 breakthrough was observed and a significant increase in oil production with water cut reduced by 4%. The detailed laboratory study and field experience are presented in this paper.

No abstract

No abstract

No abstract

No abstract