The life and efficiency of electric vehicle batteries are susceptible to temperature. The impact of cold climate dramatically decreases battery life, while at the same time increasing internal impedance. Thus, a battery thermal management system (BTMS) is vital to heat and maintain temperature range if the electric vehicle’s batteries are operating in a cold climate. This paper presents an induction heater-based battery thermal management system that aims to ensure thermal safety and prolong the life cycle of Lithium-ion batteries (Li-Bs). This study used a standard simulation tool known as GT-Suite to simulate the behavior of the proposed BTMS. For the heat transfer, an indirect liquid heating method with variations in flow rate was considered between Lithium-ion batteries. The battery and cabin heating rate was analyzed using the induction heater powers of 2, 4, and 6 kW at ambient temperatures of −20, −10, and 0 ∘C. A water and ethylene glycol mixture with a ratio of 50:50 was considered as an operating fluid. The findings reveal that the thermal performance of the proposed system is generally increased by increasing the flow rate and affected by the induction heater capacity. It is evident that at −20 ∘C with 27 LPM and 6 kW heater capacity, the maximum heat transfer rate is 0.0661 ∘C/s, whereas the lowest is 0.0295 ∘C/s with 2 kW heater capacity. Furthermore, the proposed BTMS could be a practical approach and help to design the thermal system for electric vehicles in the future.

No abstract

The fast evolving Electric vehicles (EVs) have become popular due to their zero-emission, fuel economy and better technology. However, the performance and life of batteries are very sensitive to temperature, it is important to maintain the proper temperature range. The battery thermal management system (BTMS) plays an important role in the performance of EVs. In this context, this study is conducted to evaluate the thermal performance of a battery with a parallel system using an induction heater. The GT-Suite software is used for simulation and evaluation. Mixture of water and ethylene glycol 50:50 is used as a working fluid and controlled by pump and valves. The heating rate of battery was analyzed by changing the capacity of induction heater 2, 4 and 6[Formula: see text]kW and the flow rate of fluid was 2, 3, 5, 7, 10 and 27 LPM. The simulation work predicts that the battery heating rate increases with the increase in fluid flow. The study concluded that the battery heating rate is maximum with a flow rate of 27 LPM which is the highest amount of LPM, indicating that the rise in flow rate causes the increase in heating rate of the system which is also affected by induction heater capacity.

The rising need for thermal comfort has resulted in a rapid increase in refrigeration systems’ usage and, subsequently, the need for electricity for air-conditioning systems. The ejector system can be driven by a free or affordable low-temperature heat source such as waste heat as the primary source of energy instead of electricity. Heat-driven ejector refrigeration systems become a promising solution for reducing energy consumption to conventional compressor-based refrigeration technologies. An air-conditioning system that uses the ejector achieves better performance in terms of energy-saving. This paper presents a study on the combined driven refrigeration cycle based on ejectors to maximize cycle performance. The experimental setup is designed to determine the coefficient of performance (COP) with ejector nozzle sizes 1.8, 3.6, and 5.4[Formula: see text]mm, respectively. In this system, the R-134a refrigerant is considered as a working fluid. The results depict that the efficiency is higher than that of the conventional refrigeration method due to comparing the performance of the conventional refrigeration cycle and the combined driven refrigeration cycle. The modified cycle efficiency is better than the vapor compression cycle below 0∘C, which implies sustainability at low temperatures by using low-grade thermal energy. For the improvement of mechanical efficiency, proposed cycle can be easily used.