Smoking is one of the major causes of lifestyle associated mortality and morbidity such as cancer of the oral cavity and lungs, and also cardiovascular diseases. In this study, we have provided evidences for the smoking-induced hemolysis using two methods: spectra of blood components and atomic force microscopic analysis of surface morphology. A total of 62 subjects (control = 31; smoker = 31: 21 male; 10 female in each set) were considered for the study. The findings indicate that smoking leads to potholes on the surface, swelling of shape, rupturing of erythrocytes, removal of hematoporphyrin and flushing into the plasma as metabolites of the erythrocyte. The overall morphology of the erythrocytes of the smoker group appears more like a Mexican hat. The mean surface roughness was 5.5 ± 3 nm for the smoker group, but 1.2 ± 0.2 nm for the control group. Such damages might help the toxins, (CO, peroxidants, aldehydes etc.,) to gain easy access and get strongly absorbed by the hemoglobin, leading to enhanced rates of hemolysis as shown by the spectral features of metabolites. This indicates that the average life span of the smoker’s erythrocytes is significantly less than that of the control group.

We deposit dense, ordered, thin films of Au-dodecanethiol core/shell nanoparticles by the Langmuir-Schäfer (LS) printing method, and find that their resistance at ambient temperature responds selectively and sensitively to alkane odours. Response is a rapid resistance increase due to swelling, and is strongest for alkane odours where the alkane chain is similar in length to the dodecane shell. For decane odours, we find a response to concentrations as low as 15 ppm, about 600 times below the lower explosive limit.Response is weaker, but still significant, to aromatic odours (e.g. Toluene, Xylene), while potential interferants such as polar and/or hydrogen-bonding odours (e.g. alcohols, ketones, water vapour) are somewhat rejected. Resistance is weakly dependent on temperature, and recovers rapidly and completely to its original value within the error margin of measurement.

No abstract

The use of the water-oil interface provides significant advantages in the synthesis of inorganic nanostructures. Employing the water-toluene interface, luminescent CdS nanocrystals have been obtained at a relatively modest temperature of 35• C. The diameters of the particulates can be varied between 1.0 and 5.0 nm. In addition, we have devised a new method for transferring thin films at the water-toluene interface onto solid substrates. Using this method, thin films consisting of Au and Ag nanocrystals spread over very large areas (square centimetres) are obtained in a single step. These films are directly usable as ingredients of functional devices. We show this by constructing a working amine sensor based on films of Au nanocrystals. The materials obtained have been characterized by X-ray diffraction, scanning and transmission electron microscopy, absorption and emission spectroscopy and charge transport measurements.