In this paper, by studying the engineering properties of rubber particles-improved fly ash soil, the authors provide technical parameters for setting up cold-resistance layer in the seasonal frozen zone. In the experiment, rubber particles are mixed into the fly ash soil by mass of 0%, 1%, 2%, 3%, 5% and 7% and unconfined compressive strength testing, frost heave test, insulation test and thermal conductivity test. By analyzing the test results, the authors drew the conclusion that fly ash soil improved by rubber particles has a high compressive strength, a small amount of frost heave, good insulation performance, small thermal conductivity coefficient.Therefore, improved fly ash soil with rubber particles is one of the preferred materials to set up the cold resistance layer in seasonal frost zone.

Concrete structures are often in different humidity conditions that have a significant impact on the elastic modulus of concrete, therefore, systematic research on the evolution of the law of concrete elastic modulus under different humidity conditions is needed. In this study, the variation laws of the water saturation of concrete specimens with strength grades C15, C20, and C30 were obtained, and then the influence laws of the water saturation on the concrete axial compressive strength were carried out, and the prediction model of elastic modulus of concrete with respect to water saturation was constructed. The results showed that the water saturation of concrete with strength grades C15, C20, and C30 increased with an extension of immersion time, and the water saturation showed an approximately linear rapid growth within three soaking hours, reaching 47.56%, 71.63%, and 47.29%, respectively. Note, the concrete reached saturation state when the soaking time was 240 h. The axial compressive strength with strength grades C15, C20, and C30 decreased with increased water saturation, and the axial compressive strength of saturated concrete decreased by 27.25%, 21.14%, and 20.76%, respectively, as compared with the dry state concrete. The elastic modulus of concrete with strength grades C15, C20, and C30 increased with increased water saturation, and the elastic modulus of saturated concrete was 1.18, 1.19, and 1.24 times higher than those of dry concrete, respectively.

In view of the poor effectiveness of existing potato cleaning methods in China and reflecting the findings of a research analysis of basic sizes and types of impurities on potato tubers, a gradient cleaning method for potato based on a multi-step dry-cleaning and wet cleaning operation was proposed. The method mainly consists of dry-cleaning and wet cleaning. The dry-cleaning stage, which combines vibration and brushing, could effectively remove impurities such as residual rhizomes, peeled potato skin, and large pieces of soil and crushed stone from the surface of potato tubers. The wet cleaning stage adopts the gradient cleaning method of pre-cleaning, rough cleaning and fine cleaning, which could further remove soil and crushed stone attached to the surface and hidden in the sprout eyes of potato tubers. The optimal parameter combination for the gradient cleaning method was determined as follows. The potato feeding amount was 3 t/h, the speed of the rubber chain rod mechanism was 25 r/min, the speed of the first and third brush roller was 40 r/min, the speed of the second and fourth brush roller was 56 r/min, the moving speed of the immersion mechanism conveying net chain was 0.04 m/s, the speed of the brush roller in the high pressure spray and brush roller combination mechanism was 40 r/min, the ultrasonic power was 1200 W, the ultrasonic frequency was 33 kHz, the bubble intensity was 300 L/min, and the moving speed of the conveying net chain in the ultrasonic and bubble combination mechanism was 0.05 m/s. Taking the impurity removal rate and damage rate of potato tuber as the test indexes, a potato cleaning performance test was carried out under the optimal parameters combination. The results showed that the average impurity removal rate and damage rate of potato tubers were 99.05% and 2.48%, respectively. Additionally, the operational performance fully met the requirements for potato cleaning. This study provides a new method for potato cleaning in China and can also provide a reference for cleaning other root and tuber crops.