No abstract

Bimetallic Fe/Ni nanoparticles were synthesized and their nitrate reduction capacity was studied. Nitrate (354 mg L(-1), equal to 5.71 mmol L(-1)) reduction was performed using Fe/Ni nanoparticles with various Ni contents (1.0, 5.0, 10 and 20%) in an unbuffered condition. Optimum nitrate reduction rate (1.03 +/- 0.087 x 10(-4) mol x min(-1) x greduc(-1)) was obtained with 5.0% nano-scale Fe/Ni, while only 25% nitrate (1.05 +/- 0.091 x 10(-5) mol x min(-1) x greduc(-1)) was transformed by nano-scale Fe(0) within the same reaction time, which means that these bimetallic nanoparticles are obviously more reactive than monometallic nano-scale Fe(0). For this bimetallic system a near-neutral initial pH (6.5) is more favourable than an acidic condition (2.0 and 4.0). Relatively air-stable nano-scale Fe/Ni particles were developed by slowly aging them for 22 h and exhibited similar reactivity to freshly synthesized nano-scale Fe(0). Although undesirable transformation of nitrate (91.0 +/- 0.37%) to ammonium was observed in this study, Fe/Ni particles showed a much higher nitrate reduction rate and an optimum reduction rate at near-neutral pH, which may have important implications for nitrate-contaminated site remediation.

Given the potential risks of chlorinated polycyclic aromatic hydrocarbons, the analysis of their presence in water is very urgent. We have developed a novel procedure for determining chlorinated polycyclic aromatic hydrocarbons in water based on solid-phase extraction coupled with gas chromatography and mass spectrometry. The extraction parameters of solid-phase extraction were optimized in detail. Under the optimal conditions, the proposed method showed wide linear ranges (1.0-1000 ng/L) with correlation coefficients ranging from 0.9952 to 0.9998. The limits of detection and the limits of quantification were in the range of 0.015-0.591 and 0.045-1.502 ng/L, respectively. Recoveries ranged from 82.5 to 102.6% with relative standard deviations below 9.2%. The obtained method was applied successfully to the determination of chlorinated polycyclic aromatic hydrocarbons in real water samples. Most of the chlorinated polycyclic aromatic hydrocarbons were detected and 1-monochloropyrene was predominant in the studied water samples. This is the first report of chlorinated polycyclic aromatic hydrocarbons in water samples in China. The toxic equivalency quotients of chlorinated polycyclic aromatic hydrocarbons in the studied tap water were 9.95 ng the toxic equivalency quotient m(-3) . 9,10-Dichloroanthracene and 1-monochloropyrene accounted for the majority of the total toxic equivalency quotients of chlorinated polycyclic aromatic hydrocarbons in tap water.

A rapid, simple and efficient method was first applied to the simultaneous analysis of BPA and TBBPA in commercial milk.