No abstract

No abstract

Laser additive manufacturing is an advanced material preparation technology, which has been widely used to prepare various materials, such as polymers, metals, ceramics and composites. Zirconium diboride (ZrB2) reinforced copper composite material was fabricated using laser direct energy deposition technology. The microstructure and phase composition of the composite material were analyzed, and the influence of laser energy density on the microstructure and mechanical properties of composite materials was discussed. The results showed that the needle-like ZrB2 ceramic reinforcement was successfully synthesized via an in-situ synthesis reaction. The composites were mainly composed of needle-like ZrB2, Ni dendrites and a Cu matrix. The morphological changes of Ni dendrites could be observed at the interface inside the composite material: cellular crystals → large-sized columnar dendrites → small-sized dendrites (along the solidification direction). The continuous Ni dendritic network connected the ZrB2 reinforcements together, which significantly improved the mechanical properties of the composite material. At a laser energy density of 0.20 kJ/mm2, the average microhardness of the composite material reached 294 HV0.2 and the highest tensile strength was 535 MPa. With the laser energy density increased to 0.27 kJ/mm2, the hardness and tensile strength decreased and the elongation of the Cu composites increased due to an increase in the size of the ZrB2 and a decrease in the continuity of the Ni dendritic.

Gadolinia (Gd2O3) is potentially attractive as a dispersive phase for copper matrix composites due to its excellent thermodynamic stability. In this paper, a series of 1.5 vol% nano-Gd2O3/Cu composites were prepared via an internal oxidation method followed by powder metallurgy in the temperature range of 1123–1223 K with a holding time of 5–60 min. The effects of processing parameters on the microstructure and properties of the composites were analyzed. The results showed that the tensile strength and conductivity of the nano-Gd2O3/Cu composite have a strong link with the microporosity and grain size, while the microstructure of the composite was determined by the sintering temperature and holding time. The optimal sintering temperature and holding time for the composite were 1173 K and 30 min, respectively, under which a maximum ultimate tensile strength of 317 MPa was obtained, and the conductivity was 96.8% IACS. Transmission electron microscopy observations indicated that nano-Gd2O3 particles with a mean size of 76 nm formed a semi-coherent interface with the copper matrix. In the nano-Gd2O3/Cu composite, grain-boundary strengthening, Orowan strengthening, thermal mismatch strengthening, and load transfer strengthening mechanisms occurred simultaneously.

No abstract