No abstract

Airborne particulate matter (PM) is a concern for both occupational health and the environment, and, in the ferroalloy industry, the level of such particles in the air can be considerable. Small, low-cost sensors for measuring PM have generated interest in recent years, providing widespread monitoring of PM levels in the environment. However, such sensors have not yet been sufficiently tested under conditions relevant for the indoor environment of the metallurgical industry. This study aims to bridge this gap by benchmarking the commercial, low-cost Nova PM SDS011 particle sensor in two different ferroalloy plants. Benchmarking was performed against the Fidas 200S, which has been suitability-tested and certified according to the latest EU requirements (EN 15267, EN 16450). Twelve Nova sensors were tested over 3 months at a silicomanganese alloy (SiMn) plant, and 35 sensors were tested during 1 month at a silicon (Si) plant. The results showed that the low-cost Nova sensors exhibited all the same trends and peaks in terms of PM concentration, but measured lower dust concentrations than the Fidas 200S. The difference was larger at the silicon plant, which is in line with expectations, due to the size and mass fractions of particles in Si dust compared to SiMn dust, and to the larger measurement range of the Fidas, measuring down to 180 nm compared to the Nova which measures down to 300 nm. Despite the difference in absolute values, the Nova sensors were found to provide data for comparing dust levels over time for different processes, at different locations, and under different operational conditions.

No abstract

The original version of the article unfortunately contained an error in the corresponding author's name. Instead of "Håkon Aleksander Hartvedt Olsen Myklebust" it has been wrongly displayed as "Hn Aleksander Hartvedt Olsen Myklebust". This has been corrected by publishing this correction article. The original article has been updated.Publisher's Note Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Thermal fume formation is a problem in manganese ferroalloy production and the metal production industry at large. A better understanding of the mechanisms of fume formation and the operational parameters affecting the fume formation rate may help in reducing and managing fuming. This paper aims to investigate the effects of oxygen content and gas flow rate on the fuming rate and fume particulate properties for liquid high-carbon ferromanganese. The fuming rates were attained experimentally by measuring the fume flux with respect to oxygen content and gas velocity above the metal melt. The generated fumes were also characterized in terms of particle size and element distribution between fume and melt. The fuming rates were found to steadily increase with increasing oxygen content and flow rate of the gas up to a point where the curve flattens, following theoretical predictions. However, the highest flux values measured were above the theoretical limitations of the evaporation flux in vacuo given the alloy bulk composition. It is hypothesized that the high rate of fuming is caused by an increased manganese activity at the alloy surface due to local decarburization of the alloy in contact with the oxidizing gas. Graphical Abstract