Transtibial PCL reconstruction with remnant preservation resulted in satisfactory clinical, functional, radiological, and morphological outcomes. The results of combined posterolateral rotatory instability were comparable with those for isolated PCL reconstruction with adequate PLC reconstruction.

BackgroundThe purpose of this study was to analyze biomechanical properties of a novel wedge locking plate in medial open wedge high tibial osteotomy (OWHTO) in a porcine tibial model.MethodsA uniform 8-mm OWHTO was performed in 12 porcine tibiae. Six of them were subsequently fixed with the plate without a wedge, whereas the other 6 were additionally reinforced with a metal wedge of 8 mm. Biomechanical properties (stiffness, displacement of the osteotomy gap, and failure load) were evaluated under axial load. The different modes of failure were also investigated.ResultsThe plate showed an axial stiffness of 2,457 ± 450 N/mm with a wedge and 1,969 ± 874 N/mm without a wedge. The maximum failure load was 5,380 ± 952 N with a wedge and 4,354 ± 607 N without a wedge. The plate with a wedge had a significantly greater failure load and significantly less displacement of medial gap at failure than that without a wedge (p = 0.041 and p = 0.002, respectively). The axial stiffness was not different between the two types of fixation. Most failures were caused by lateral cortex breakage and there was no implant failure.ConclusionsThe novel wedge locking plate showed excellent biomechanical properties and an additional wedge provided significant improvement. This plate can be a good fixation method for OWHTO.

PurposeTo investigate the incidence of scapular dyskinesis (SD) in patients with rotator cuff tears using pre‐ and postoperative 3D computed tomography, analyze the changes in scapular kinematics that occur after arthroscopic rotator cuff repair, and identify the contributing clinical factors. MethodsThirty‐five patients (mean age, 62.5 ± 8.4 years) were included. Four scapular angles (upward rotation, internal rotation, protraction, and posterior tilt) were measured. The patients were categorized into three pre‐existing SD types according to the difference in measured scapular angles between the affected and unaffected sides (type 1 SD, posterior tilt angle difference <  − 5°; type 2 SD, internal rotation angle difference > 5°; and type 3 SD, upward rotation angle difference > 5°). The prevalence, factors influencing SD, and outcomes were compared between the improved and sustained SD groups. ResultsTwenty three of the 35 patients (65.7%) with rotator cuff tears had SD (type 1, 11; type 2, six; type 3, six). Of the 23 preoperative SD patients, 12 (52.1%) showed improved SD postoperatively. Most of the patients with improved SD (9/12) had type 1 SD (p = 0.021) and a significantly improved posterior tilt angle (p = 0.043). The improvement in SD was correlated with a higher range of motion of forward flexion and higher Constant scores (all p < 0.05). No healing failure occurred in the improved SD group (p = 0.037). ConclusionThe prevalence of SD was high in patients with degenerative rotator cuff tears. More than half of the SD cases, especially type 1 SD, improved postoperatively. SD recovery correlated with better function and successful rotator cuff healing. Level of evidenceIV.

No abstract

No abstract