We have used a high-precision, easy, low-cost and rapid method of oxygen isotope analysis applied to various O-bearing matrices, organic and inorganic (sulfates, nitrates and phosphates), whose (18)O/(16)O ratios had already been measured. It was first successfully applied to (18)O analyses of natural and synthetic phosphate samples. The technique uses high-temperature elemental analysis-pyrolysis (EA-pyrolysis) interfaced in continuous-flow mode to an isotope ratio mass spectrometry (IRMS) system. Using the same pyrolysis method we have been able to generate a single calibration curve for all those samples showing pyrolysis efficiencies independent of the type of matrix pyrolysed. We have also investigated this matrix-dependent pyrolysis issue using a newly developed pyrolysis technique involving 'purge-and-trap' chromatography. As previously stated, silver phosphate being a very stable material, weakly hygroscopic and easily synthesized with predictable (18)O/(16)O values, could be considered as a good candidate to become a reference material for the determination of (18)O/(16)O ratios by EA-pyrolysis-IRMS.

The quantitative conversion of organically bound oxygen into CO, a prerequisite for the (18)O/(16)O analysis of organic compounds, is generally performed by high-temperature conversion in the presence of carbon at ∼1450°C. Since this high-temperature procedure demands complicated and expensive equipment, a lower temperature method that could be utilized on standard elemental analyzers was evaluated. By substituting glassy carbon with carbon black, the conversion temperature could be reduced to 1170°C. However, regardless of the temperature, N-containing compounds yielded incorrect results, despite quantitative conversion of the bound oxygen into CO. We believe that the problems were partially caused by interfering gases produced by a secondary decomposition of N- and C-containing polymers formed during the decomposition of the analyte. In order to overcome the interference, we replaced the gas chromatographic (GC) separation of CO and N(2) by reversible CO adsorption, yielding the possibility of collecting and purifying the CO more efficiently. After CO collection, the interfering gases were vented by means of a specific stream diverter, thus preventing them from entering the trap and the mass spectrometer. Simultaneously, a make-up He flow was used to purge the gas-specific trap before the desorption of the CO and its subsequent mass spectrometric analysis. Furthermore, the formation of interfering gases was reduced by the use of polyethylene as an additive for analytes with a N:O ratio greater than 1. These methodological modifications to the thermal conversion of N-containing analytes, depending on their structure or O:N ratio, led to satisfactory results and showed that it was possible to optimize the conditions for their individual oxygen isotope ratio analysis, even at 1170°C. With these methodological modifications, correct and precise δ(18)O results were obtained on N-containing analytes even at 1170°C. Differences from the expected standard values were below ±1‰ with standard deviations of the analysis <0.2‰.

A general method for calculating multidimensional Franck–Condon integrals for polyatomic molecules is given. These integrals are derived by means of a multivariable generating function which incorporates both the transformation of the normal mode coordinates between initial and final electronic states and their frequency changes. The normal mode transformation or mode mixing (Duschinsky effect) scrambles the occupations of the normal modes, leading to unusual distributions, which at certain values of the angles of rotation are confined to some of the modes only or even to a single mode. Mathematically, this selectivity can be described in terms of normal mode displacements generated by the rotation matrix from the potential minima of the ground and excited states. These normal mode displacements, as well as the set of mixed frequency change parameters due to mode mixing, have no counterparts in the parallel mode approximation and are the reason that multidimensional Franck–Condon integrals are of formidable analytical complexity. This complexity is analyzed with particular attention to the symmetry of the integrals with respect to the interchange of quantum occupation numbers. Finally calculation of scattered intensities in the resonance Raman process is made, showing a strong dependence of the corresponding cross section upon the rotation angle.

The isotope ratio of each of the light elements preserves individual information on the origin and history of organic natural compounds. Therefore, a multi-element isotope ratio analysis is the most efficient means for the origin and authenticity assignment of food, and also for the solution of various problems in ecology, archaeology and criminology. Due to the extraordinary relative abundances of the elements hydrogen, carbon, nitrogen and sulfur in some biological material and to the need for individual sample preparations for H and S, their isotope ratio determination currently requires at least three independent procedures and approximately 1 h of work. We present here a system for the integrated elemental and isotope ratio analysis of all four elements in one sample within 20 min. The system consists of an elemental analyser coupled to an isotope ratio mass spectrometer with an inlet system for four reference gases (N(2), CO(2), H(2) and SO(2)). The combustion gases are separated by reversible adsorption and determined by a thermoconductivity detector; H(2)O is reduced to H(2). The analyser is able to combust samples with up to 100 mg of organic material, sufficient to analyse samples with even unusual elemental ratios, in one run. A comparison of the isotope ratios of samples of water, fruit juices, cheese and ethanol from wine, analysed by the four-element analyser and by classical methods and systems, respectively, yielded excellent agreements. The sensitivity of the device for the isotope ratio measurement of C and N corresponds to that of other systems. It is less by a factor of four for H and by a factor of two for S, and the error ranges are identical to those of other systems.

The novel HTC system coupled to an isotope ratio mass spectrometer resulted in significantly improved sensitivity. The system is suitable for salt-containing liquids and compounds that are resistant to oxidation, and it offers a large concentration range. A second paper (which follows this one in this issue) will present a more comprehensive assessment of the analytical performance with a broad set of solutions and real samples. This highly efficient TOC stable isotopic analyzer will probably open up new possibilities in biogeochemical carbon cycle research.