No abstract

No abstract

Polyethylene (PE) fibers were prepared by ethylene extrusion polymerization with an MCM‐41‐supported titanocene catalyst. The morphological and mechanical properties of these nascent PE fibers were investigated. Three levels of fibrous morphologies were identified in the fiber samples through an extensive scanning electron microscopy study. Extended‐chain PE nanofibrils with diameters of about 60 nm were the major morphological units present in the fiber structure. The nanofibrils were parallel‐packed into individual microfibers with diameters of about 1–30 μm. The microfibers were further aggregated irregularly into fiber aggregates and bundles. In comparison with commercial PE fibers and data reported in the literature, the individual microfibers produced in situ via ethylene extrusion polymerization without posttreatment exhibited a high tensile strength (0.3–1.0 GPa), a low tensile modulus (3.0–7.0 GPa), and a high elongation at break (8.5–20%) at 35 °C. The defects in the alignment of the nanofibrils were believed to be the major reason for the low modulus values. It was also found that a slight tensile drawing could increase the microfiber strength and modulus. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 2433–2443, 2003

Pore and surface diffusion of carbon dioxide (CO(2)) and ethylene (C(2)H(4)) in the nanopores of ordered mesoporous silica fibers about 200 microm in length was measured by the transient gravimetric method. The experimentally determined pore diffusivity data, coupled with the porosity, pore size, and fiber length, are used to obtain the actual length of the nanopores in silica fibers. These measurements reveal a structure of the ordered nanopores whirling helically around the fiber axis with a spiral diameter of about 15 microm and a pitch value of 1.6 microm. At room temperature the surface diffusion contributes about 10% to the total diffusional flux for these two gases in the nanopores of the ordered mesoporous silica fibers. The surface diffusion coefficients for the ordered mesoporous silica fibers are about 1 order of magnitude larger than the non-ordered mesoporous alumina or silica with similar pore size.