Aims In order to avoid the potential for elevated serum lipid levels as a consequence of long term sedation with propofol, a formulation of propofol 6% in LipofundinA MCT/LCT 10% (Propofol 6% SAZN) has been developed. The pharmacokinetics, induction of anaesthesia and safety characteristics of this new formulation were investigated after bolus injection and were compared with the commercially available product ( propofol 1% in IntralipidA 10%, DiprivanA-10) and propofol 1% in LipofundinA MCT/LCT 10% (Propofol 1% SAZN). Methods In a randomised double-blind study, 24 unpremedicated female patients received an induction dose of propofol of 2.5 mg kg −1 over 60 s which was followed by standardized balanced anaesthesia. The patients were randomized to receive propofol as Propofol 6% SAZN, Propofol 1% SAZN or DiprivanA-10. Results For all formulations the pharmacokinetics were adequately described by a tri-exponential equation, as the propofol concentrations collected early after the injection suggested an additional initial more rapid phase. The average values for clearance (CL), volume of distribution at steady-state ( V d,ss ), elimination half-life (t 1/2,z ) and distribution half-life (t 1/2,l2 ) observed in the three groups were 32±1.5 ml kg −1 min −1 , 2.0±0.18 l kg −1 , 95±5.6 min and 3.4±0.20 min, respectively (mean±s.e.mean, n=24) and no significant differences were noted between the three formulations ( P >0.05). The half-life of the additional initial distribution phase (t 1/2,l1 ) in all subjects ranged from 0.1 to 0.6 min. Anaesthesia was induced successfully and uneventfully in all cases, and the quality of induction was adequate in all 24 patients. The induction time did not vary between the three formulations and the average induction time observed in the three groups was 51±1.3 s which corresponded to an induction dose of propofol of 2.1±0.06 mg kg −1 (mean±s.e.mean, n=24). The percentage of patients reporting any pain on injection did not vary between the formulations and was 17% for the three groups. No postoperative phlebitis or other venous sequelae of the vein used for injection occurred in any of the patients at recovery of anaesthesia nor after 24 h. Conclusions From the above results, we conclude that the alteration of the type of emulsion and the higher concentration of propofol in the new parenteral formulation of propofol does not affect the pharmacokinetics and induction characteristics of propofol, compared with the currently available product. Propofol 6% SAZN can be administered safely and has the advantage of a reduction of the load of fat and emulsifier which may be preferable when long term administration of propofol is required.
The pharmacokinetics, pharmacodynamics and safety characteristics of propofol 6% SAZN are in good agreement with those of the 1% formulations. Propofol 6% SAZN therefore provides a useful alternative to the commercially available 1% formulation for short-term sedation in the intensive care unit. Expected advantages in long-term sedation of the 6% over 1% formulation are the subject of an ongoing study.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.