In this paper, a novel microgrid (MG) concept suitable for direct current (DC) multibus architectures is depicted. Multibus feature is improved in order to distribute power in DC using a number of buses at different voltage level. A teachers offices building that houses several kinds of loads, including a charging station for electric vehicles (EV), is considered to validate the strategy. Several topologies of power electronics converters (PECs) are included in the system to perform specific tasks and providing isolation between bus and final loads. In order to develop the PECs, first, a switching function is used to obtain average model of each converter. Then, converters design is done by using well known methods that allow to obtain parameter values of all the devices in every version of each kind of converter. A hierarchical control is selected to govern the direct current microgrid (DCMG). At a lower control level, local control stage is implemented and tuned using models and designs obtained, with linear controllers in some PECs and classic strategies in others. In higher control level, there is a supervisory strategy that prioritizes the use of generated power to supply the building’s loads. This energy management system (EMS) is based in Petri net theory; it consists of a start-up test, then source condition synchronous algorithm and load condition synchronous algorithm operate the DCMG according to the mentioned priority. Finally, PECs are tested on standalone, performing in closed loop, facing load changes to verify the adequate operation. Some trajectories of a simplified version of the CDMG are tested with local control in order to validate the multibus multivoltage concept. In order to verify coordinated control, some events managed by EMS are presented.
This article presents the development of a low-cost control hardware in the loop platform for the validation and analysis of controllers used for the management of power sharing between the main grid and a DC microgrid. The platform is made up of two parts: a main grid interconnection system emulator (MGISE) and a controller under test (CUT). The MGISE operates on a 260 V DC bus and includes a 1000 W photovoltaic array, a DC variable load and a single H full bridge converter (HFBC). The CUT includes a phase locked loop and a main cascade control structure composed of two PI controllers. Both the MGISE and the CUT were embedded on an NI myRIO-1900 development board and programmed using LabVIEW virtual instrumentation software. These devices communicate with each other using analog signals representing the AC side current, the DC side voltage, and the HFBC control signal. The MGISE operates with an integration time of 6 µs and its performance is validated by comparing it with a simulation in PSIM. The integration time of the MGISE, the development boards used, as well as its programming environment, and the results obtained from the comparison with PSIM simulation, show that the proposed platform is useful for the validation of controllers for power sharing, with a simple implementation process compared to other hardware description methods and with a low-cost platform.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.