The sealing ability of new adhesive root canal filling materials was evaluated using a new dye penetration method. Twentyeight single-rooted mandibular premolars were randomly divided into four groups of seven teeth each and filled by lateral condensation using one of these combinations: Resilon point with Epiphany sealer (RE); gutta-percha point with Sealapex sealer (GS); gutta-percha point with dentin activator and Superbond sealer (GDS); or gutta-percha point with Accel primer, dentin activator, and Superbond sealer (GADS). Amount of 0.06％ methylene blue dye solution (MB) that leaked from the coronal portion to the apical area was measured with a spectrophotometer at one, four, eight, 15, and 30 days in an accumulative manner. The total amount of leaked MB on day 30 was significantly higher for GDS than the other combinations (p<0.05).

Objectives: The purpose of this study was to evaluate the accuracy of diagnosing vertical root fractures (VRFs) by comparing the volume of bone defects in VRFs with those in nonVRFs on reconstructed three-dimensional (3D) models (TDMs) using CBCT. Methods: 32 maxillary pre-molars and anterior teeth with radiolucent areas were evaluated on pre-operative CBCT images. Of the 32 teeth, 16 had a fractured root (VRF group) and 16 had a non-fractured root (non-VRF group). The radiolucent area of each tooth was traced in each dimension [mesiodistal, buccolingual and horizontal (the apicoincisal aspect)] by two observers, and 3D images were reconstructed with the Amira ® software (Visage Imaging Inc., Richmond, Australia). The volume, V, of the TDM was divided into the coronal side and the periapical side at the horizontal slice through the apical foramen, and v was defined as the volume of the coronal side. The values of v/V were calculated for all cases. The Mann-Whitney U test was used to compare values between the VRF group and the non-VRF group (p , 0.05). A receiver operating characteristic (ROC) curve was constructed to select the optimal cut-point. Results: There was a statistically significant difference in the value of v/V between the two groups (p , 0.05). With a cut-point derived from the ROC curve, and the sensitivity, specificity and accuracy of predicting the VRFs were 1.00, 0.75 and 0.88, respectively. Conclusions: Lesions resulting from VRFs can be distinguished from those of non-VRFs on 3D CBCT images with a high degree of accuracy, based on their different 3D shapes.

No abstract

The aim of this study was to investigate coronal leakage after obturation with mineral trioxide aggregate (MTA), resin-based sealer, and silicon-based sealer for open apical foramina and to evaluate pathway of leakage. Twenty-eight maxillary premolars were used, and instrumented to ISO size #80. Teeth were randomly divided into four groups as follows: Group A filled with MTA, Group B with gutta-percha and resin-based sealer, Group C with polymer-based material and resin-based sealer, and Group D with gutta-percha and silicon-based sealer. All samples were evaluated for coronal leakage with methylene blue solution and spectrophotometry. After leakage testing, samples were cut, and sections were observed. Dye leakage of Group A was significantly lowest among all groups at 15 days and 30 days. Defects which induced coronal leakage in resin-based sealer were observed at 7 mm from the apex. Coronal leakage after obturation with MTA for open apical foramina was significantly lower than resin-based sealer and silicon-based sealer.