The shape effect of gold (Au) nanomaterials on the efficiency of cancer radiotherapy has not been fully elucidated. To address this issue, Au nanomaterials with different shapes but similar average size (∼50 nm) including spherical gold nanoparticles (GNPs), gold nanospikes (GNSs), and gold nanorods (GNRs) were synthesized and functionalized with poly(ethylene glycol) (PEG) molecules. Although all of these Au nanostructures were coated with the same PEG molecules, their cellular uptake behavior differed significantly. The GNPs showed the highest cellular responses as compared to the GNSs and the GNRs (based on the same gold mass) after incubation with KB cancer cells for 24 h. The cellular uptake in cells increased in the order of GNPs > GNSs > GNRs. Our comparative studies indicated that all of these PEGylated Au nanostructures could induce enhanced cancer cell-killing rates more or less upon X-ray irradiation. The sensitization enhancement ratios (SERs) calculated by a multitarget single-hit model were 1.62, 1.37, and 1.21 corresponding to the treatments of GNPs, GNSs, and GNRs, respectively, demonstrating that the GNPs showed a higher anticancer efficiency than both GNSs and GNRs upon X-ray irradiation. Almost the same values were obtained by dividing the SERs of the three types of Au nanomaterials by their corresponding cellular uptake amounts, indicating that the higher SER of GNPs was due to their much higher cellular uptake efficiency. The above results indicated that the radiation enhancement effects were determined by the amount of the internalized gold atoms. Therefore, to achieve a strong radiosensitization effect in cancer radiotherapy, it is necessary to use Au-based nanomaterials with a high cellular internalization. Further studies on the radiosensitization mechanisms demonstrated that ROS generation and cell cycle redistribution induced by Au nanostructures played essential roles in enhancing radiosensitization. Taken together, our results indicated that the shape of Au-based nanomaterials had a significant influence on cancer radiotherapy. The present work may provide important guidance for the design and use of Au nanostructures in cancer radiotherapy.

A simple and highly efficient method for dopamine (DA) detection using water-soluble silicon nanoparticles (SiNPs) was reported. The SiNPs with a high quantum yield of 23.6% were synthesized by using a one-pot microwave-assisted method. The fluorescence quenching capability of a variety of molecules on the synthesized SiNPs has been tested; only DA molecules were found to be able to quench the fluorescence of these SiNPs effectively. Therefore, such a quenching effect can be used to selectively detect DA. All other molecules tested have little interference with the dopamine detection, including ascorbic acid, which commonly exists in cells and can possibly affect the dopamine detection. The ratio of the fluorescence intensity difference between the quenched and unquenched cases versus the fluorescence intensity without quenching (ΔI/I) was observed to be linearly proportional to the DA analyte concentration in the range from 0.005 to 10.0 μM, with a detection limit of 0.3 nM (S/N = 3). To the best of our knowledge, this is the lowest limit for DA detection reported so far. The mechanism of fluorescence quenching is attributed to the energy transfer from the SiNPs to the oxidized dopamine molecules through Förster resonance energy transfer. The reported method of SiNP synthesis is very simple and cheap, making the above sensitive and selective DA detection approach using SiNPs practical for many applications.

Microbial viability assessment plays a key role in many areas such as pathogen detection, infectious disease treatment and antimicrobial drug development. Many conventional viability dyes (such as propidium iodide, PI) used for differentiating live/dead microbes suffer from notable cytotoxicity, poor photostability and are of high cost. Thus their applications for accurate microbial viability determination are limited. Herein, for the first time we report the successful synthesis of fluorescent carbon dots (CDs) from bacteria via one-step hydrothermal carbonization. Benefiting from their highly negative surface charge (the zeta potential is as high as around -42 mV) and suitable size, the CDs can selectively stain dead microbial cells (bacteria and fungi) but not live ones. Importantly, compared to the widely used commercial dye PI, the developed CDs possess many great advantages including low cytotoxicity, multicolor imaging ability, excellent photostability and high selectivity. Moreover, because the synthetic method is simple, inexpensive and eco-friendly, this type of CD is suitable for large-scale production, making it an excellent candidate for microbial live/dead differentiation and viability assessment. The present work explores the feasibility of using bacteria to fabricate novel CDs and broadens the applications of CDs for biomedical applications.

Water-dispersible nanomaterials with superbright photoluminescence (PL) emissions and narrow PL bandwidths are urgently desired for various imaging applications. Herein, for the first time, we prepared ultrasmall organosilica nanodots (OSiNDs) with an average size of ∼2.0 nm and ∼100% green-emitting PL quantum efficiency via a one-step hydrothermal treatment of two commercial reagents (a silane molecule and rose bengal). In particular, the structural reorganization and halide loss of rose bengal during the hydrothermal treatment contribute to the ultrahigh quantum yield and low phototoxicity of OSiNDs. Owing to their low pH-induced precipitation/aggregation property, the as-prepared OSiNDs can be used as excellent lysosomal trackers with many advantages: (1) They have superior lysosomal targeting ability with a Pearson's coefficient of 0.98; (2) The lysosomal monitoring time of OSiNDs is up to 48 h, which is much longer than those of commercial lysosomal trackers (<2 h); (3) They do not disturb the pH environment of lysosomes and can be used to visualize lysosomes in living, fixed, and permeabilized cells; (4) They exhibit intrinsic lysosomal tracking ability without the introduction of lysosome-targeting ligands (such as morpholine) and superior photostability; (5) The easy, cost-effective, and scalable synthetic method further ensures that these OSiNDs can be readily used as exceptional lysosomal trackers. We expect that the ultrasmall OSiNDs with superior fluorescence properties and easily modifiable surfaces could be applied as fluorescent nanoprobes, light-emitting diode phosphor, and anticounterfeiting material, which should be able to promote the preparation and application of silicon-containing nanomaterials.

unique optical properties such as strong luminescence, high photostability, and size-tunable emission wavelength. [ 1 ] However, these semiconductor QDs usually have the problem of low biocompatibility. Thus it is urgent to fi nd alternative fl uorescent nanoparticles with similar optical properties. Silicon, the second most abundant element on earth, is nontoxic (or with low toxicity) and essential for human health. [ 2 ] Because of their superb electronic, optical, and mechanical properties, silicon-based nanostructures (such as nanospheres, nanoribbons, nanowires, nanorods, and nanodots) have been extensively employed in a large variety of applications, including those related to optoelectronics, energy, catalysis, bioanalysis, and biology. [ 3 ] With many superior characteristics including excellent optical properties, easy surface modifi cation capability, superb biocompatibility, and low cytotoxicity, fl uorescent silicon nanoparticles (SiNPs) are being considered as replacements for current fl uorescence labels in biological, biomedical, and biochemical applications, including longterm bioimaging [ 2c,d , 4 ] and sensing. [ 5 ] Numerous methods for preparing free-standing SiNPs have been developed and can be classifi ed into three categories: [ 6 ] (1) the top-down approach using bulk silicon materials (e.g., etching of bulk silicon [ 7 ] and breaking down silicon rich Fluorescent silicon nanoparticles (SiNPs) have shown potential applications in bioimaging/biolabelling, sensing, and nanomedicine/cancer therapy due to their superior properties such as excellent photostability, low cytotoxicity, and versatile surface modifi cation capability. Here, a simple, high-yield, and one-pot method is developed to prepare superbright, water-soluble, and amine-functionalized SiNPs with photoluminescence quantum yield (PLQY) comparable to fl uorescent II-VI semiconductor quantum dots (QDs) but with much lower cytotoxicity. By introducing a commercially available amine-containing silane molecule, N-[3-(trimethoxysilyl)propyl]ethylenediamine (DAMO), water-soluble SiNPs are prepared with PLQY of 82.4% via a microwave-assisted method. To the best of our knowledge, this is the highest PLQY value ever reported for water-soluble fl uorescent SiNPs. The silicon element in our SiNPs is mainly four-valent silicon and thus these SiNPs may also be termed as oxidized silicon nanospheres or silica nanodots. We have also demonstrated the importance of the silane structure (e.g., a suitable amine content) on the photoluminescence property of the prepared SiNPs. As revealed by the time-resolved photoluminescence technique, the highest PLQY value of DAMO SiNPs is correlated with their monoexponential decay with a relatively long fl uorescence lifetime. In addition, the potential use of these SiNPs has also been demonstrated for fl uorescent patterning/printing and ion sensing (including Cu 2+ and Hg 2+).