In the mouth, biofilm formation occurs on all soft and hard surfaces. Microbial colonization on such surfaces is always preceded by the formation of a pellicle. The physicochemical surface properties of a pellicle are largely dependent on the physical and chemical nature of the underlying surface. Thus, the surface structure and composition of the underlying surface will influence on the initial bacterial adhesion. The aim of this review is to evaluate the influence of the surface roughness and the restorative material composition on the adhesion process of oral bacteria. Both in vitro and in vivo studies underline the importance of both variables in dental plaque formation. Rough surfaces will promote plaque formation and maturation. Candida species are found on acrylic dentures, but dentures coating and soaking of dentures in disinfectant solutions may be an effective method to prevent biofilm formation. Biofilms on gold and amalgam are thick, but with low viability. Glass-ionomer cement collects a thin biofilm with a low viability. Biofilms on composites cause surface deterioration, which enhances biofilm formation. Biofilms on ceramics are thin and highly viable

This study aimed to investigate the effect of low-level laser therapy (LLLT) on tooth sensitivity induced by in-office bleaching. Sixty-six patients enrolled in this randomized clinical trial. Following the in-office procedure with 40% hydrogen peroxide, the participants were randomly divided into three groups. The patients in group 1 received irradiation from a low-level red laser (LLRL; 660 nm, 200 mW, 15 s, 12 J/cm(2)), whereas participants in group 2 were subjected to a low-level infrared laser (LLIL; 810 nm) under similar conditions as in group 1. In group 3 (placebo), the laser treatment was the same as that in groups 1 and 2, but without energy output. The degree of tooth sensitivity was recorded at 1, 24, and 48 h after bleaching using a visual analog scale (VAS). The change in tooth shade was measured 30 days after tooth whitening. The intensity of tooth sensitivity was not significantly different between groups at 1 h after bleaching (p > 0.05). At 24 h after therapy, pain level was significantly lower in the LLIL group compared to the LLRL and placebo groups (p < 0.05). At 48 h after bleaching, VAS scores in the LLIL and LLRL groups were comparable to each other (p > 0.05) and both were significantly lower than that of the placebo group (p < 0.05). There was no significant difference in the efficacy of tooth whitening among groups (p > 0.05). LLLT with an infrared diode laser could be recommended as a suitable strategy to reduce the intensity of tooth sensitivity after in-office bleaching.

This study investigated the combined effect of fractional CO(2) laser irradiation and fluoride on treatment of enamel caries. Sixty intact premolars were randomly assigned into four groups and then stored in a demineralizing solution to induce white spot lesions. Tooth color was determined at baseline (T1) and after demineralization (T2). Afterwards, the teeth in group 1 remained untreated (control), while group 2 was exposed to an acidulated phosphate fluoride (APF) gel for 4 min. In groups 3 and 4, a fractional CO(2) laser was applied (10 mJ, 200 Hz, 10 s) either before (group 3) or through (group 4) the APF gel. The teeth were then immersed in artificial saliva for 90 days while subjected to daily fluoride mouthrinse and weekly brushing. Color examinations were repeated after topical fluoride application (T3) and 90 days later (T4). Finally, the teeth were sectioned, and microhardness was measured at the enamel surface and at 30 and 60 μ from the surface. In both lased groups, the color change between T1 and T4 stages (∆E(T1-T4)) was significantly lower than those of the other groups (p < 0.05). Laser irradiation followed by fluoride application (group 3) caused a significant increase in surface microhardness compared to APF alone and control groups (p < 0.05). Microhardness at depths of 30 and 60 μ was also significantly greater in group 3 compared to those of all other groups (p < 0.05). Application of a fractional CO(2) laser before fluoride therapy is suggested for recovering the color and rehardening of demineralized enamel.

Objectives:This study investigated the effects of post bleaching treatments to prevent restaining and the change of enamel surface microhardness after dental bleaching in vitro.Methods:Sixty intact human incisor teeth were stained in tea solution and randomly assigned into four groups (n=15). Then samples were bleached for two weeks (8 hours daily) by 15% carbamide peroxide. Tooth color was determined both with a spectrophotometer and visually before bleaching (T1) and immediately after bleaching (T2). Next, it was applied in group 1 fluoride (Naf 2%) gel for 2 minutes, and in group 2 a fractional CO2 laser (10 mJ, 200 Hz, 10 s), and in group 3, nanohydroxyapatite gel for 2 minutes. The bleached teeth in group 4 remained untreated (control group). Then teeth placed in tea solution again. Color examinations were repeated after various post bleaching treatments (T3) and restaining with tea (T4) and color change values recorded. The microhardness was measured at the enamel surface of samples. Data was analyzed using ANOVA, Tukey HSD test and Dunnett T3 (α = 0.05).Results:Directly after bleaching (ΔE T3-T2), the treatment with nanohydroxyapatite showed significantly the least color lapse in colorimetric evaluation. In experimental groups, the color change between T3 and T4 stages (ΔE T4-T3) was significantly lower than control group (P < 0.05). Different methods of enamel treatment caused a significant increase in surface microhardness compared to control group (P < 0.05).Significance:Application of fluoride, fractional CO2 laser and nanohydroxyapatite as post bleaching treatments are suggested for prevention of stain absorption and increasing the hardening of bleached enamel.

The aim of this clinical trial was to compare the clinical performance of three different adhesive systems over 18 months in noncarious cervical lesions (NCCLs). Thirty patients, with at least three noncarious cervical lesions, were enrolled in the study. One operator randomly restored a total of 90 lesions with resin composite (Herculite XRV). The restorations were bonded with either Optibond FL (OF), three-step total-etch; Optibond Solo Plus (OS), two-step total-etch; or Optibond All-In-One (OA), one step self-etch. The restorations were clinically evaluated at baseline and after six, 12, and 18 months using the eight United States Public Health Services criteria. Data were analyzed using Friedman and Wilcoxon signed ranks tests (p<0.05). After 18 months, the retention rate was (OF) 96.5%, (OS) 93.1%, and (OA) 89.7%. Differences among the three adhesive systems for evaluated criteria were not observed in comparison of the mean Alfa score percentages. There was a significant increase in marginal discoloration for (OA) adhesive after 18 months compared with baseline (p=0.011). Other restoration criteria had no statistically significant differences among the three adhesives (p>0.05). With the exception of marginal discoloration, the clinical effectiveness of three types of adhesive systems in NCCLs was acceptable after 18 months. However, using the one-step self-etch adhesive may lead to some marginal discolorations.