This study numerically intends to evaluate the effects of arc-shaped fins on the melting capability of a triplex-tube confinement system filled with phase-change materials (PCMs). In contrast to situations with no fins, where PCM exhibits relatively poor heat response, in this study, the thermal performance is modified using novel arc-shaped fins with various circular angles and orientations compared with traditional rectangular fins. Several inline and staggered layouts are also assessed to maximize the fin’s efficacy. The effect of the nearby natural convection is further investigated by adding a fin to the bottom of the heat-storage domain. Additionally, the Reynolds number and temperature of the heat-transfer fluid (HTF) are evaluated. The outcomes showed that the arc-shaped fins could greatly enhance the PCMs’ melting rate and the associated heat-storage properties. The melting rate is 17% and 93.1% greater for the case fitted with an inline distribution of the fins with a circular angle of 90° and an upward direction, respectively, than the cases with uniform rectangular fins and no fins, which corresponded to the shorter melting time of 14.5% and 50.4%. For the case with arc-shaped fins with a 90° circular angle, the melting rate increases by 9% using a staggered distribution. Compared to the staggered fin distribution, adding an extra fin to the bottom of the domain indicates adverse effects. The charging time reduces by 5.8% and 9.2% when the Reynolds number (Re) rises from 500 to 1000 and 1500, respectively, while the heat-storage rate increases by 6.3% and 10.3%. When the fluid inlet temperature is 55°C or 50°C, compared with 45°C, the overall charging time increases by 98% and 47%, respectively.

In this study, the effect of fin number and size on the solidification output of a double‐tube container filled with phase change material (PCM) was analyzed numerically. By altering the fins' dimensions, the PCM's heat transfer performance is examined and compared to finless scenarios. To attain optimal performance, multiple inline configurations are explored. In addition, the initial conditions of the heat transfer fluid (HTF), including temperature and Reynolds number, are considered in the analysis. The research results show a significant impact of longer fins with higher numbers on improving the solidification rate of PCM. The solidification rate increases by 67%, 170%, 308%, and 370% for cases with 4, 9, 15, and 19 fins, respectively, all with the same fin length and initial HTF boundary condition. The best case results in a solidification time that is 4.45 times shorter compared to other fin number and dimension scenarios. The study also found that moving from Reynolds numbers 500 to 1000 and 2000 reduced discharging times by 12.9% and 22%, respectively, and increased heat recovery rates by 14.4% and 27.9%. When the HTF entrance temperature was 10°C and 15°C, the coolant temperature showed that the entire discharging time decreased by 37.5% and 23.1% relative to the solidification time when the initial temperature was 20°C. Generally, this work highlights that increasing the length and number of fins enhances thermal efficiency and the phase change process.

No abstract