ABSTRACT

Deep tectonic tremor, which is extremely sensitive to small stress variations, could be used to monitor fault zone processes during large earthquake cycles and aseismic processes before large earthquakes. In this study, we develop an algorithm for the automatic detection and location of tectonic tremor beneath the southern Central Range of Taiwan and examine the spatiotemporal relationship between tremor and the 4 March 2010 ML6.4 Jiashian earthquake, located about 20 km from active tremor sources. We find that tremor in this region has a relatively short duration, short recurrence time, and no consistent correlation with surface GPS data. We find a short‐term increase in the tremor rate 19 days before the Jiashian main shock, and around the time when the tremor rate began to rise one GPS station recorded a flip in its direction of motion. We hypothesize that tremor is driven by a slow‐slip event that preceded the occurrence of the shallower Jiashian main shock, even though the inferred slip is too small to be observed by all GPS stations. Our study shows that tectonic tremor may reflect stress variation during the prenucleation process of a nearby earthquake.

Three earthquake sequences, each with two main earthquakes of almost the same magnitudes (M L from 5.9 to 7.0 with differences less than 0.1), have recently been observed in Taiwan. The two largest earthquakes in each sequence occurred with a short delay time between them, were strikingly similar in terms of magnitude, location and/or focal mechanism and are referred to as doublets. They were markedly distinct from typical single mainshock sequences. Our estimated static stress field generated by the first shock in the doublet shows that the second shock and most of their aftershocks were located within a region where static stress increased substantially. Thus, a possible explanation for earthquake doublet is that seismic energy for each shock had accumulated independently within adjacent crustal volumes, separated by an asperity, and that the second shock is triggered by the increased static stress after the first one. An important implication of doublet sequence is that works by emergency response teams after the first earthquake could be made more hazardous by the second.

In the Tatun mountain area of northern Taiwan are two strong motion stations approximately 2.5 km apart, TAP056 and TAP066 of the TSMIP network. The accelerometer at station TAP056 is often triggered by earthquakes, but that at TAP066 station is not. Comparisons of vertical and horizontal peak ground accelerations reveal PGA in the vertical, east-west, and north-south components at TAP056 station to be 3.89, 7.57, and 5.45 times those at station TAP066, respectively. The PGA ratio does not seem to be related to earthquake source or path. Fourier spectra of earthquake records at station TAP056 always have approximately the same dominant frequency; however, those at station TAP066 are different due to different sources and paths of different events. This shows that spectra at TAP056 station are mainly controlled by local site effects. The spectral ratios of TAP056/TAP066 show the S-wave is amplified at around 8~10 Hz. The horizontal/vertical spectral ratios of station TAP056 also show a dominant frequency at about 6 and 8~10 Hz. After dense microtremor surveying and the addition of one accelerometer just 20 meters away from the original observation station, we can confirm that the top soft soil layer upon which the observation station is constructed generates the local site response at station TAP056.

No abstract