No abstract

No abstract

In traditional battery equalization strategy, open-circuit voltage (OCV) of battery cells was used to judge the difference of SOC between them. However, OCV is not only determined by SOC but also influenced by internal resistance, polarization voltage, capacity, and other nonlinear factors. As a result, OCV is not an ideal indicator of SOC differences, especially in transient conditions. In order to control battery consistency accurately, it is best to use SOC directly as standard for battery consistency judgment and control. To achieve this, an algorithm that can estimate SOC of multiple battery cells simultaneously with low computational complexity and high accuracy is needed. Limited by computing speed of Battery Control Unit (BCU), existing SOC estimation method is hard to estimate SOC of each battery cell simultaneously with high accuracy. In this research, a new SOC estimation strategy was proposed to estimate SOC of multiple battery cells simultaneously for battery equalization control. Battery model is established based on experimental data, and a processor-in-the-loop test system was established to verify the actual performance of the proposed algorithm. Results of simulation and test indicate that the proposed algorithm can estimate SOC of multiple battery cells simultaneously and achieved good real-time performance and high accuracy.

Bismuth oxide (Bi2O3) and its composites have good electrocatalytic performance. Quartz column is a good kind of catalyst carrier with the characteristics of high mechanical strength and good stability. A novel Bi-modified quartz column particle electrode (BQP) was prepared by the dipping-calcination method. The characterization results revealed that Bi2O3was successfully loaded on quartz column. The optimum preparation condition was calcining at 550°C for 4 h. Electrocatalytic performance was evaluated by the degradation of phenol and the results indicated that the triclinic phase of Bi2O3showed the best electrocatalytic property. Besides, when the dosage concentration of the particle electrode was 125 g/L and the electrolytic voltage was 12 V, the degradation rate of phenol (200 mg/L) reached the highest (94.25%), compared with 70.00% of that in two-dimensional (2D) system. In addition, the removal rate of chemical oxygen demand (COD) was 75.50%, compared with 53.30% of that in 2D system. The reusability and regeneration of BQP were investigated and the results were good. Mechanism of enhanced electrochemical oxidation by BQP was evaluated by the capture of hydroxyl radical.

No abstract