No abstract

The phase formation and stabilization behaviors of calcia partially stabilized zirconia (Ca-PSZ) were investigated with regard to the CaO content and post-heat treatment. Sintered specimens were prepared by adding 2, 3, 4, and 5 mol% to CaO to ZrO2, and post-heat treatment were conducted. In the X-ray diffraction pattern, the monoclinic peak decreased, the tetragonal peak increased upon CaO doping, and no CaZrO3 peak was observed. Transmission electron microscopy images of the Ca-PSZ showed that the d-spacing of 4CSZ (200)m extended from 0.260 nm to 0.266 nm subsequent to post-heat treatment. The coefficient of thermal expansion gradually increased in accordance with the dopant concentration, in addition, it increased even after the post-heat treatment. These results are related to the increase in tetragonal phase, which has a relatively higher coefficient of thermal expansion than that of the monoclinc phase. According to the Vickers hardness measurement, the hardness of all specimens increased gradually as the concentration of CaO increased, and the hardness of the 5CSZ was improved from 676 to 774 Hv by the post-heat treatment.

The redox behavior of the catalyst and the catalytic decomposition of carbon monoxide (CO) were investigated in the synthesis process of multi‐wall carbon nanotubes (MWCNT) using Ni/MgO catalyst. The surface morphology of the heated Ni layer was observed by TEM to confirm the formation of NiO particles (50 nm or less) and NiO (222). The chemical reaction behavior of the catalyst in CO the atmosphere was displayed via TG‐DSC analysis, and the reduction of NiO was revealed due to the mass decrease of 2.71 wt% and the exothermic peak at around 400°C. The deposition of carbon was identified with an increase in mass and the exothermic peak near 600°C. Ni (111) and carbon (002) facets was taken place in a diffraction pattern of carbon deposited catalyst, indicating the reduction in NiO and the graphitic carbon deposition. The crystallinity of the graphitic carbon was analyzed as the ratios of 0.998 for ID/IG and 0.26 for sp3/sp2 in Raman and photoelectron spectra. The encapsulated Ni in MWCNT was observed through TEM‐EDS, verifying the activation of the catalyst by CO.

The degradation behavior of yttria-stabilized zirconia by thermal aging was investigated in terms of phase transformation, local atomic structure, and electrical conductivity. The average grain size of 8YSZ was increased from 20.83 μm to 25.81 μm with increasing aging temperature. All 8YSZ samples degraded at different temperatures had a predominantly cubic structure. The (400) peak of 8YSZ deteriorated at 1300 and 1400 °C shifted to a high angle, and the peak of tetragonal was not indexed. For 8YSZ degraded at 1500 °C, the (400) peak shifted to a lower angle, and the peak of tetragonal was identified. Analysis of the local microstructure of aged 8YSZ using extended X-ray absorption fine structure showed that the intensity of the Zr-O peak gradually increased and that the intensity of the peak of cationic Zr decreased as the aging temperature increased. The changes in the peaks indicate that the oxygen vacancies were reduced and Y3+ ions escaped from the lattice, leading to the destabilization of 8YSZ. The activation energies of 8YSZ at 1300 °C and 1400 °C were derived to be 0.86 and 0.87 eV, respectively, and the activation energy of 8YSZ at 1500 °C increased significantly to 0.92 eV. With the thermal deterioration of 8YSZ, the cation (Y3+) escaped from the lattice and the number of oxygen vacancies decreased, resulting in the formation of a tetragonal structure and high activation energy at 1500 °C.

No abstract