Photovoltaic (PV) plant failures have a significant influence on PV plant security, reliability, and energy balance. Energy losses produced by a PV plant are due to two large causes: failures and inefficiencies. Knowing the relative influence of energy losses due to failures and energy losses due to inefficiencies on the PV plant energy balance contribute to the optimization of its design, commissioning, and maintenance tasks. This paper estimates the failure rates, grouped by components, and the relative impact of the failures on the PV plant energy balance through real operation and maintenance follow-up data of 15 PV plants in Spain and Italy for 15 months. Results show that the influence of failures in energy losses of all analysed PV plants is low, reaching a maximum value of 0.96% of the net energy yield. Solar field energy losses only represent 4.26% of all failure energy losses. On the other hand, energy losses due to inefficiencies have represented between 22.34% and 27.58% of the net energy yield.

No abstract

No abstract

The world population is growing by 1 billion people every 10 years. There will come a time when there will be more people to feed but less land to grow food. Greenhouses can be the solution to this problem because they provide the highest production yield per m2 and also use less water, provide food safety, and offer high quality. Photosynthetic active radiation (PAR) favors vegetable growth with a specific blue and red light ratio. Thus, increasing the amount of red light improves chlorophyll absorption and photosynthetic efficiency. In this article, we present a hybrid system that combines luminescent materials and photonic crystals for better management of the light reaching the greenhouse. The luminescent dyes considered herein are combined ensuring a Förster resonance energy transfer (FRET) nonradiative mechanism to enhance the absorption range. The designed photonic crystal maximizes reflections in the Near-Infrared (NIR) range, and therefore, thermal losses are minimized. Thus, by converting harmful or ineffective radiation for plant growth to the PAR region, we aim to demonstrate growth-condition enhancement for the different vegetables that have been used as a model.

Photonic crystals have the advantage of minimizing thermal losses from solar cells, reflecting the solar radiation that is not absorbed by the photovoltaic device. To optimize this optical response, photonic crystals are designed considering the relative position of the Bragg peak and the bandgap of the solar cell, under normal incident irradiation conditions. The aim of this research article was to determine experimentally the optical limits of a solar cell coupled to a photonic crystal acting as beam splitter. For that purpose, the photovoltaic system was characterized under indoor and outdoor conditions; angular dependence of the irradiation source was determined in each case, and both results were compared with good agreement. Moreover, other parameters such as irradiation spectrum and polarization of the light were investigated. The main conclusion is that photovoltaic performance is highly affected by the Bragg peak shifting and the profile is distorted, due to the angular dependence with the sun. These experimental limits must be considered at the early design stage to avoid performance losses.