No abstract

Comprehensive measurements of the DLG in 0D, 1D, and 2D provide an accurate assessment of DLG value required during TPS commissioning. These DLG measurements can also be used as a quality control tool to quantify changes of the MLC calibration and leaf gap consistency, which is critical for the accurate delivery of dynamically delivered SW IMRT plans.

No abstract

Improved treatment techniques in radiation therapy provide incentive to reduce treatment margins, thereby increasing the necessity for more accurate geometrical setup of the linear accelerator and accompanying components. In the present paper, we describe the development of a novel device that enables precise and automated measurement of geometric parameters for the purpose of improving initial setup accuracy, and for standardizing repeated quality control activities. The device consists of a silicon photodiode array, an evaluation board, a data acquisition card, and a laptop. Measurements that demonstrate the utility of the device are also presented. Using the device, we show that the radiation light field congruence for both 6 and 15 MV beams is within 1.3 mm. The maximum measured disagreement between radiation field edges and light field edges was 1.290±0.002 mm, while the smallest disagreement between the light field and radiation field edge was 0.016±0.003 mm. Because measurements are automated, ambiguities resulting from interobserver variability are removed, greatly improving the reproducibility of measurements across observers. We expect the device to find use in consistency measurements on linear accelerators used for stereotactic radiosurgery, during the commissioning of new linear accelerators, or as an alternative to film or other commercially available devices for performing monthly or annual quality control checks.PACS numbers: 87.55.Qr, 87.56.Fc, 87.57.N‐, 87.15mn, 87.15mq