BackgroundIn Germany, about 86.7 % of the dentists have stated to suffer from pain in the neck and shoulder region. These findings are predominantly based on surveys. Therefore the objective of this study is to conduct a kinematic analysis of occupational posture in dentistry.MethodsTwenty one dentists (11 f/10 m; age: 40.1 ± 10.4 years) have participated in this examination. The CUELA-System was used to collect kinematic data of the activities on an average dental workday. A detailed, computer-based task analysis took place parallel to the kinematic examination. Through the synchronization of data collected from both measurements, patterns of posture were arranged chronologically and in conjunction with the tasks performed: (I) “treatment” (II) “office” and (III) “other activities”. For the data analysis, characteristic data of joint angular distributions (percentiles P05, P25, P50, P75 and P95) of head, neck and torso at pre-defined tasks were examined and assessed corresponding to ergonomic standards.ResultsForty one percent of tasks executed on an average dental workday can be categorized as the treatment of patients. These tasked are most frequently performed in “straight back” positions (78.7 %), whereas 20.1 % were carried out in a “twisted or inclined” torso posture, 1.1 % “bowed” and only 0.1 % “bowed and twisted/inclined to the side” upper body position. In particular, it can be observed that in the area of the cervical and thoracic spine the 75th and 95th percentile show worse angular values during treatment than during non-dental tasks. For the period of treatment (at a standardized dental chair construction), a seated position with a strong inclination of the thoracic spine to the right while the lumbar spine is inclined towards the left is adopted.ConclusionThe kinematic analysis of dentists illustrates typical patterns of postures during tasks that are essential to the dental treatment of patients. The postures in the area of the cervical and thoracic spine have higher angular values during treatment compared to other dental tasks. Consistently, appropriate ergonomic design measures to optimize the dental chair and equipment as well as integrated training in ergonomics as part of the study of dentistry to prevent musculoskeletal are recommended.Electronic supplementary materialThe online version of this article (doi:10.1186/s12891-016-1288-0) contains supplementary material, which is available to authorized users.

BackgroundHow a dentist works, such as the patterns of movements performed daily, is also largely affected by the workstation Dental tasks are often executed in awkward body positions, thereby causing a very high degree of strain on the corresponding muscles. The objective of this study is to detect those dental tasks, during which awkward postures occur most frequently. The isolated analysis of static postures will examine the duration for which these postures are maintained during the corresponding dental, respectively non-dental, activities.Methods: 21 (11f/10 m) dentists (age: 40.1 ± 10.4 years) participated in this study. An average dental workday was collected for every subject. To collect kinematic data of all activities, the CUELA system was used. Parallel to the kinematic examination, a detailed computer-based task analysis was conducted. Afterwards, both data sets were synchronized based on the chronological order of the postures assumed in the trunk and the head region. All tasks performed were assigned to the categories “treatment” (I), “office” (II) and “other activities” (III). The angle values of each body region (evaluation parameter) were examined and assessed corresponding to ergonomic standards. Moreover, this study placed a particular focus on static positions, which are held statically for 4 s and longer.ResultsFor “treatment” (I), the entire head and trunk area is anteriorly tilted while the back is twisted to the right, in (II) and (III) the back is anteriorly tilted and twisted to the right (non-neutral position). Static positions in (I) last for 4–10s, static postures (approx. 60%) can be observed while in (II) and (III) in the back area static positions for more than 30 s are most common. Moreover, in (II) the back is twisted to the right for more than 60 s in 26.8%.ConclusionAwkward positions are a major part of a dentists’ work. This mainly pertains to static positions of the trunk and head in contrast to “office work.” These insights facilitate the quantitative description of the dentist profession with regard to the related physical load along with the health hazards to the musculoskeletal system. Moreover, the results allow for a selective extraction of the most unfavorable static body positions that dentists assume for each of the activities performed.

ObjectivesTo conduct a kinematic comparison of occupational posture in orthodontists and dentists in their workplace.DesignObservational study.SettingDentist surgeries and departments of orthodontics at university medical centres in Germany.ParticipantsA representative sample of 21 (10 female, 11 male) dentists (group G1) and 21 (13 female, 8 male) orthodontists (G2) with one male dropout in G2.Outcome measuresThe CUELA (computer-assisted acquisition and long-term analysis of musculoskeletal loads) system was used to analyse occupational posture. Parallel to the recording through the CUELA system, a software-supported analysis of the activities performed (I: treatment; II: office; III: other activities) was carried out. In line with ergonomic standards the measured body angles are categorised into neutral, moderate and awkward postures. Activities between the aforementioned groups are compared using the stratified van Elteren U test and the Wilcoxon–Mann–Whitney U test. All p values are subject to the Bonferroni–Holm correction. The level of significance is set at 5%.ResultsThe percentage of time spent on activities in categories I–II–III was as follows: dentists 41%–23%–36% and orthodontists 28%–37%–35%. The posture analysis of both groups showed, for all percentiles (P5–95), angle values primarily in the neutral or moderate range. However, depending on the activity performed, between 5% and 25% of working hours were spent in unfavourable postures, especially in the head-and-neck area. Orthodontists have a greater tendency than dentists to perform treatment activities with the head and torso in unfavourable positions. The statistically significant differences between the two groups with regard to the duration and the relevance of the activities performed confirm this assumption for all three categories (p<0.01, p<0.05).ConclusionsGenerally, both groups perform treatment activities in postures that are in the neutral or medium range; however, dentists had slightly more unfavourable postures during treatment for a greater share of their work day.

BackgroundThis study aims at identifying orthodontic activities with the highest frequency of unfavorable/awkward and static postures held over a period of more than 4 s based on kinematic analysis. Moreover, a separate analysis of static postures for orthodontic and non-orthodontic activities serves to evaluate the duration for which these particular postures are assumed.MethodsIn total, 21 (13f/8 m) orthodontists (age: 31.5 ± 3.8 years) participated in this study. CUELA, a personal measurement system, was used to collect kinematic data for all orthodontic activities in a working day. Angle values of the head and torso were evaluated in accordance with ergonomic standards. Only those postures that were held statically for 4 s and longer were selected for further analysis. Alongside the kinematic analysis, the activities performed on-site were also subject to a detailed computerized analysis. The synchronization of data collected from both measurements arranges the patterns of posture found chronologically and in conjunction with the orthodontic activities performed ((I) “treatment” (II) “office” and (III) “other activities”).ResultsFor (I) we observed an anterior inclination of the head and torso area as well as a twist of the head and neck area to the right. We found anterior back inclination and lateral back torsion to the right for (II) and (III). If, furthermore, we differentiate the duration of static postures, there are primarily short to medium-term (4–30s) static postures identified for (I). Also, categories (II) and (III) predominantly demonstrate static back postures with a duration of up to 30 s. With regard to (II) we observed that the back is ventrally inclined for 10.1% of the total activity duration.ConclusionsDuring treatment static strains are observed in the entire head and torso area. On the contrary, static postures prevalent in the torso area are essential for activities of the other categories, particularly office work. These findings allow for a careful selection of unfavorable and static postures for each of the activities performed and help to develop specific preventive measures.

Orthodontists do take characteristic postures during treatment activities with highest angle values. The postures differ in the area of head and cervical spine with regard to the various activities carried out in the 3 categories.