The influence of the types and amounts of oxygen (O), nitrogen (N), and/or phosphorus (P) heteroatoms on the surface of carbon nanotubes (CNTs) on stability and catalytic activity in the oxygen reduction reaction (ORR) was investigated in alkaline media. It is shown that functionalization of CNTs leads to growth of the electrochemically active surface and to an increase in activity in the ORR. At the same time, a decrease in stability is observed after functionalization of CNTs under accelerated corrosion testing in alkaline media. These results are most significant on CNTs after functionalization in HNO3, due to the formation of a large number of structural defects. However, subsequent doping with N and/or P atoms provides a further activity increase and enhances the corrosion stability of CNTs. Thus, as shown by the studies of characteristic parameters (electrochemical active surface values (SEAS); E1/2; corrosion stability), CNTs doped with N and NP are promising catalytic systems that can be recommended for use as fuel cell cathodes. An important condition for effective doping is the synthesis of carboxyl and carbonyl oxygen-containing groups on the surface of CNTs.

In order to develop highly efficient and stable catalysts for oxygen reduction reaction (ORR) that do not contain precious metals, it is necessary to modify carbon nanotubes (CNT) and define the effect of the modification on their activity in the ORR. In this work, the modification of CNTs included functionalization by treatment in NaOH or HNO3 (soft and hard conditions, respectively) and subsequent doping with nitrogen (melamine was used as a precursor). The main parameters that determine the efficiency of modified CNT in ORR are composition and surface area (XPS, BET), hydrophilic–hydrophobic surface properties (method of standard contact porosimetry (MSP)) and zeta potential (dynamic light scattering method). The activity of CNT in ORR was assessed following half-wave potential, current density within kinetic potential range and the electrochemically active surface area (SEAS). The obtained results show that the modification of CNT with oxygen-containing groups leads to an increase in hydrophilicity and, consequently, SEAS, as well as the total (overall) current. Subsequent doping with nitrogen ensures further increase in SEAS, higher zeta potential and specific activity in ORR, reflected in the shift of the half-wave potential by 150 mV for CNTNaOH-N and 110 mV for CNTHNO3-N relative to CNTNaOH and CNTHNO3, respectively. Moreover, the introduction of N into the structure of CNTHNO3 increases their corrosion stability.

Platinum deposited on dispersed materials has so far been the most demanded catalyst for creating cathodes for a wide range of electrochemical power sources. This paper sets out to investigate the effect of carbon nanotube (CNT) modification by O, N, and P atoms on the structural, electrocatalytic, and corrosion properties of the as-synthesized monoplatinum catalysts. The investigated Pt/CNTmod catalysts showed an increased electrochemically active platinum surface area and electrical conductivity, as well as an increased catalytic activity in the oxygen reduction reaction (ORR) in alkaline electrolytes. The improved characteristics of Pt/CNT catalysts are explained by alterations in the composition and number of groups, which are formed on the CNT surface, and their electronic structure. By the sum of the main characteristics, Pt/CNTHNO3+N and Pt/CNTHNO3+NP are the most promising catalysts for use as cathode materials in alkaline media.

No abstract

Bimetallic catalysts containing platinum and transition metals (PtM, M = Mo, Ni, CoCr) were synthesized on carbon nanotubes (CNTs) functionalized in an alkaline medium. Their platinum content is 10–15% by mass. PtM/CNTNaOH are active in both the hydrogen oxidation reaction (HOR) and the oxygen reduction reaction (ORR) in alkaline electrolytes. Although catalysts based on a single transition metal are inactive in the HOR, their activity in the cathode process of ORR increases relative to CNTNaOH. When using the rotating ring-disk electrode method for ORR, PtM/CNT showed a high selectivity in reducing oxygen directly to water. In HOR, the PtM/CNT catalyst had an activity comparable to that of a commercial monoplatinum catalyst. The results obtained show that it is possible to use the PtM/CNT catalyst in an alkaline fuel cell both as an anode and as a cathode.