Poly(hydroxybutyrate) (PHB)-based films, reinforced with bacterial cellulose (BC) or cellulose nanocrystals (CNC) and plasticized using a molecular (tributyrin) or a polymeric plasticizer (poly(adipate diethylene)), were produced by solvent casting. Their morphological, thermal, wettability, and chemical properties were investigated. Furthermore, the effect of adding both plasticizers (20 wt % respect to the PHB content) and biobased selected nanofillers added at different contents (2 and 4 wt %) on disintegrability in composting conditions was studied. Results of contact angle measurements and calorimetric analysis validated the observed behavior during composting experiments, indicating how CNC aggregation, due to the hydrophilic nature of the filler, slows down the degradation rate but accelerates it in case of increasing content. In contrast, nanocomposites with BC presented an evolution in composting similar to neat PHB, possibly due to the lower hydrophilic character of this material. The addition of the two plasticizers contributed to a better dispersion of the nanoparticles by increasing the interaction between the cellulosic reinforcements and the matrix, whereas the increased crystallinity of the incubated samples in a second stage in composting provoked a reduction in the disintegration rate.

Poly(3-hydroxybutyrate) (PHB)-based bionanocomposites were prepared using various percentages of cellulose nanocrystals (CNCs) by a solution casting method. CNCs were prepared from microcrystalline cellulose using sulfuric acid hydrolysis. The influence of CNCs on PHB properties was evaluated using differential scanning calorimetry, Fourier transform infrared spectroscopy, X-ray diffraction, thermogravimetry and tensile testing. Vapor permeation and light transmission of the materials were also measured. Differential scanning calorimetric tests demonstrated that CNCs were effective PHB nucleation agents. Tensile strength and Young's modulus of PHB increased with increasing CNC concentration. Moreover, the PHB/CNC bionanocomposites exhibited reduced water vapor permeation compared to neat PHB and had better UV barrier properties than commodity polymers such as polypropylene. It was found that nanocomposites with 6 wt% of CNCs had the optimum balance among thermal, mechanical and barrier properties.