No abstract

No abstract

More than 96% of steel in the world is produced via the method of continuous casting. The flow condition in the mould, where the initial solidification occurs, has a significant impact on the quality of steel products. It is important to have timely, and perhaps automated, control of the flow during casting. This work presents a new concept of using contactless inductive flow tomography (CIFT) as a sensor for a novel controller, which alters the strength of an electromagnetic brake (EMBr) of ruler type based on the reconstructed flow structure in the mould. The method was developed for the small-scale Liquid Metal Model for Continuous Casting (mini-LIMMCAST) facility available at the Helmholtz-Zentrum Dresden-Rossendorf. As an example of an undesired flow condition, clogging of the submerged entry nozzle (SEN) was modelled by partly closing one of the side ports of the SEN; in combination with an active EMBr, the jet penetrates deeper into the mould than when the EMBr is switched off. Corresponding flow patterns are detected by extracting the impingement position of the jets at the narrow faces of the mould from the CIFT reconstruction. The controller is designed to detect to undesired flow condition and switch off the EMBr. The temporal resolution of CIFT is 0.5 s.

The flow structure in the mold of a continuous steel caster has a significant impact on the quality of the final product. Conventional sensors used in industry are limited to measuring single variables such as the mold level. These measurements give very indirect information about the flow structure. For this reason, designing control loops to optimize the flow is a huge challenge. A solution for this is to apply non-invasive sensors such as tomographic sensors that are able to visualize the flow structure in the opaque liquid metal and obtain information about the flow structure in the mold. In this paper, ultrasound Doppler velocimetry (UDV) is used to obtain key features of the flow. The preprocessing of the UDV data and feature extraction techniques are described in detail. The extracted flow features are used as the basis for real time feedback control. The model predictive control (MPC) technique is applied, and the results show that the controller is able to achieve optimum flow structures in the mold. The two main actuators that are used by the controller are the electromagnetic brake and the stopper rod. The experiments included in this study were obtained from a laboratory model of a continuous caster located at the Helmholtz-Zentrum Dresden Rossendorf (HZDR).

No abstract