Pseudomonas aeruginosa san ai degraded individual selected petroleum compounds: n-hexadecane, n-nonadecane, fluorene, phenanthrene, and pyrene with high efficiency, at initial concentrations of 20 mg L−1 and in seven days.

The mutual impact of low-quality lignite and high-density polyethylene (HDPE) during open system pyrolysis was investigated, aiming to improve utilization of lignite with simultaneous treatment of HDPE waste. Pyrolysis of lignite, HDPE, and their mixture (mass ratio, 1:1) was performed at temperatures 400, 450, 500, 550, and 600 °C. Initial substrates and pyrolysis products were characterized by thermogravimetric analysis (TGA), gas chromatography–mass spectrometry (GC–MS), specific carbon isotope analysis of individual hydrocarbons (δ13C), Rock-Eval pyrolysis, and elemental analysis. The positive synergetic effect during co-pyrolysis of lignite/HDPE mixture was observed at temperatures ≥450 °C, with the greatest being at 500 °C. The highest yield of liquid co-pyrolysis products with a similar composition to that of crude oils is also noticed at 500 °C. The yields of liquid and gaseous products and quality of pyrolytic products obtained by co-pyrolysis of lignite/HDPE mixture are notably improved compared with pyrolysis of lignite alone. On the other hand, data obtained from pyrolysis of HDPE alone indicate that it cannot be concurrent to well-developed catalytic thermal processes for polymer recycling. However, concerning the huge amount of produced HDPE, at least part of this plastic material can be reused for advanced thermal treatment of lignite, particularly in countries where this low-rank coal represents the main source of energy.

Pyrolysis of high density polyethylene (HDPE) in the open system was studied. A plastic bag for food packing was used as a source of HDPE. Pyrolysis was performed at temperatures of 400, 450 and 500 °C, which were chosen based on thermogravimetric analysis. The HDPE pyrolysis yielded liquid, gaseous and solid products. Temperature rise resulted in the increase of conversion of HDPE into liquid and gaseous products. The main constituents of liquid pyrolysates are 1-n-alkenes, n-alkanes and terminal n-dienes. The composition of liquid products indicates that the performed pyrolysis of HDPE could not serve as a standalone operation for the production of gasoline or diesel, but preferably as a pre-treatment to yield a product to be blended into a refinery or petrochemical feed stream. The advantage of a liquid pyrolysate in comparison to crude oil is the extremely low content of aromatic hydrocarbons and the absence of polar compounds. The gaseous products have desirable composition and consist mainly of methane and ethene. The solid residues do not produce ash by combustion and have high calorific values. Co-pyrolysis of HDPE with mineral-rich lignite indicated positive synergetic effect at 450 and 500 °C, which is reflected through the increased experimental yields of liquid and gaseous products in comparison to theoretical ones.

No abstract

No abstract