In this study, the influence of alloying elements on the mechanical properties of iron borides FeB and Fe2B formed in Fe-B-X (X = C, Cr, Mn, V, W, Mn + V) alloys were evaluated using instrumented indentation measurement. The microstructural characterization of the alloys was performed by means of X-ray diffraction and scanning electron microscope equipped with an energy dispersive X-ray analyzer. The fraction of the phases present in the alloys was determined either by the lever rule or by image analysis. The hardest and stiffest FeB formed in Fe-B-X (X = C, Cr, Mn) alloys was observed in the Fe-B-Cr alloys, where indentation hardness of HIT = 26.9 ± 1.4 GPa and indentation modulus of EIT = 486 ± 22 GPa were determined. The highest hardness of Fe2B was determined in the presence of tungsten as an alloying element, HIT = 20.8 ± 0.9 GPa. The lowest indentation hardness is measured in manganese alloyed FeB and Fe2B. In both FeB and Fe2B, an indentation size effect was observed, showing a decrease of hardness with increasing indentation depth.

Nanomechanical properties of iron borides, FeB and Fe2B were studied in Fe-Mn-B ternary alloys. The alloys were produced by arc melting method using high purity powders, which were subsequently annealed at temperature of 873 K and 1223 K, until fully equilibrated for a time period of 2160 hours and 1440 hours, respectively. Based on results obtained from experimental study and thermodynamic modeling of Fe-Mn-B system the solubility of Mn in these borides was determined. For the purpose of this study the influence of heat treatment temperature, as well as, the solubility of Mn in these borides on their nanomechanical properties is investigated. Nanomechanical properties, including determination of indentation modulus and hardness were measured using nanoindentation testing machine equipped with Berkovich type diamond indenter. The indentation process was carried out using an indentation depth controlled method, to a maximum depth of 500 nm.

No abstract